tuonov
Member Since: 28 Nov 2016
Location: London
Posts: 57
![](templates/vbnew/images/spacer.gif)
![2005 Discovery 3 TDV6 HSE Auto Zambezi Silver 2005 Discovery 3 TDV6 HSE Auto Zambezi Silver](../images/veh/zambezi_silver.gif)
|
Front lower arm replacement - any tips? |
|
Hi,
I’m halfway through replacing my front lower arms. I’ve undone all the bolts, but am stuck at 2 points - the ball joint bolt is stuck solid, and the rear pivot bolt is also stuck to the Bush, presumably corroded on.
Anyone have any tips? My ball joint splitter fork isn’t wide enough to get around the Land Rover one, and my cup type splitter isn’t large enough. Hammering seems to do nothing, and heat around the bracket hasn’t helped either!
|
22nd Aug 2018 6:29 pm |
|
|
SantaCruz
Member Since: 22 Jan 2012
Location: Salisbury, Wiltshire
Posts: 564
![](templates/vbnew/images/spacer.gif)
![2016 Discovery 4 3.0 SDV6 SE Tech Auto Aruba 2016 Discovery 4 3.0 SDV6 SE Tech Auto Aruba](../images/veh/aruba.gif)
|
not sure about the ball joint splitter... but i used an angle grinder to cut all the bolts off. I actually ended up cutting the ball joint out with the angle grinder too.. generated so much heat it fell out Si
2016 Disco 4 SE Tech
2019 Fiesta ST3
2021 GBS Zero
|
22nd Aug 2018 6:40 pm |
|
|
Discomadness
Member Since: 19 Jan 2015
Location: Caerphilly
Posts: 2256
![](templates/vbnew/images/spacer.gif)
![2007 Discovery 3 TDV6 HSE Auto Buckingham Blue 2007 Discovery 3 TDV6 HSE Auto Buckingham Blue](../images/veh/buckingham_blue.gif)
|
Have you got the nut off the ball joint ? If you have wind it back on a few threads and then belt the housing the ball joint cone goes into with a ball pein hammer. It’ll fall out easy. Iirc there a “lumpy” bit on the strut which looks ideal place to whack it. Jarrod
Current : D3 2007 HSE - AKA the lemon
-beanie grille
-detango with led bulbs
-club body off rebuild. TWICE.
|
22nd Aug 2018 6:55 pm |
|
|