Member Since: 23 Sep 2007
Location: Adelaide
Posts: 406
LRA Steel Protection Bar (NOT A Bar)
Have LRA always had the option of a steel protection bar? I hadnt realised if they did?
http://www.landrover.com.au/au/en/Vehicles...0Packs.htmMY2010 D4 HSE 3.0, e-diff, 19inch MTR's; LLAMS Height adjustor, LR f & r light guards, LR side steps, LR bright finish side door mouldings; LR/Mantec G4 front bash plate, LR G4 Winch kit, Warn 9500lb Winch; GOE compressor guard, Uniden UHF, LR bright finish roof rails, LR G4 driving light kit, LR G4 ladder, 4 x extra rear compartment 12V sockets, Traxide dual battery system and Optima Yellowtop battery, ORS drawer system / fridge slide, LED rear compartment lighting.
24th Dec 2007 3:41 am
Sniegy
Member Since: 01 May 2006
Location: Melbourne
Posts: 72
Hi BlackPerth,
Yes, This was available when the vehicle was first released, Have fitted a few od these, just a note tho' if u have front park sensors they will need to be turned off. Have done this to a few customers vehicles as thats what they wanted!!! D4 Alaska/Almond 2.7 TDV6 with E-diff & extra's..
Keep smilin' Pete.
24th Dec 2007 8:57 am
robertpearse
Member Since: 09 Dec 2007
Location: Woodend
Posts: 31
ISTR the outer pair of sensors still work okay with the barThe End
24th Dec 2007 9:51 am
Sniegy
Member Since: 01 May 2006
Location: Melbourne
Posts: 72
Merry Christmas to u Rob & hope the family are well.
Slimer, I stand to be corrected as the instructions & our parts catalogue say front sensors to be turned off/disabled. I havent had a chance to play with them & only disconnect the inner 2, but would assume the ecu would pick this & then chime as the sensors would be faulty....(Continually beep or such) D4 Alaska/Almond 2.7 TDV6 with E-diff & extra's..
I'm sure the official way is to disable all of them and doubt you can disable just one pair in software and as you say disconnecting them throws up an error. I'm pretty sure that back when TFC and me both had the bar fitted he disabled his inner pair (I didn't have front PDC on that D3) by putting a bit of butyl tape over them
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
