No dont use the can wire it causes problems on the car. Did you not get a remote with it so you can go in the menu setup? If the dip switches are set wrong then it wont switch the screens.
Flack
2nd Dec 2017 7:09 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10372
The remote itself doesn't seam to work. So I need to investigate that.
2nd Dec 2017 7:37 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10372
Wonder if it thinks the car is moving so won't display anything ?
Or don't these care about that ??
2nd Dec 2017 8:36 pm
M3DPO
Member Since: 22 Sep 2010
Location: Notts.
Posts: 8119
The reverse camera should only work whe reverse is selected with the ignition switched on, it takes priority over all other inputs, you should not be able to have a blank screen when reverse is selected. Power is taken from the reverse +positive cable to the camera. Any changes to the dip switches must be made while the car is sleeping i.e. Parking light on, any changes will not take effect until the car has gone to sleep.
You can only scroll forwards when changing AV inputs with the button switch.It can when others can't,
It will when others won't,
It goes where others don't.
2nd Dec 2017 8:37 pm
M3DPO
Member Since: 22 Sep 2010
Location: Notts.
Posts: 8119
Pete K wrote:
The remote itself doesn't seam to work. So I need to investigate that.
Have you got the receiver "eye" plugged in correctly and pointing the remote (fitted with new batteries) at itIt can when others can't,
It will when others won't,
It goes where others don't.
2nd Dec 2017 8:41 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10372
Eye is plugged in
R Battery has plenty of volts
2nd Dec 2017 9:02 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10372
Turns out this Rev.2 version from Sune, does require connection to the CAN.
Thankfully it's a private CAN just between the nav and display.
So now when I press the Nav hard key I can select between AV1,2,3,nav
They disabled the Mode button on these because they added the CAN facility.
I got the remote working, but still can't move the F-ing reversing lines
31st Dec 2017 6:09 pm
M3DPO
Member Since: 22 Sep 2010
Location: Notts.
Posts: 8119
You need to go into the factory settings
It can when others can't,
It will when others won't,
It goes where others don't.
Last edited by M3DPO on 31st Dec 2017 8:10 pm. Edited 1 time in total
31st Dec 2017 7:51 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10372
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum