I want to remove the trim containing the side vent and headlight controls, so I can install a switch there. I have removed the center trim many times before by just pulling. I think this is the same, but after some tough pulling, no luck. Is there something I am missing?
[/img]David
'05 LR3 Zambezi Silver
ARB Bull Bar
Superwinch EP9.0
Rasta Sill Guards
Land Rover Raised Air Intake
Hannibal Roof Rack
Rear Access Ladder
15th Jul 2007 6:22 pm
DiscoDunc
Member Since: 08 May 2006
Location: Bristol
Posts: 16390
Give a good pull from the bottom straight towards you. It is tight but if you pull hard enough it will come out. Then pull from the bottom and pull down. That will unattache the vent.Duncan
-----------------------------------------------------
If I'd known I was going to be so thirsty this morning I'd have drunk more beer last night.
FFRR Autobiography 4.4 SDV8 MY17
D4 HSE MY13 SOLD
FFRR 3.6 Vogue TDV8 SOLD
D4 HSE MY10 SOLD
D4 SE TECH MY15 SOLD
D4 XS MY12 SOLD
D4 HSE MY10 SOLD
D3 HSE MY06 - Re-Cycled Worldwide
15th Jul 2007 6:37 pm
bkehoe
Member Since: 25 Feb 2006
Location: Wexford
Posts: 1481
Pull it from the bottom only, don't pull it at the top, as it swings upwards when the clips at the bottom release.IE - 05 D3 TDV6 HSE - Zambezi Silver
SA - 07 VW Golf TDI - White - Sold!
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
