Member Since: 30 Jun 2010
Location: Sligo/ Belfast
Posts: 244
@ Robbie - I must try and update my profile, and yes I do love help! As I said, this task would be impossible without the support of this forum.
I managed to get the air compressor to fire. The relay and a fuse had been removed in the front. I used some cable to do a simple test, the compressor ran. However, the system still went into fault mode and the car did not raise.
Would a poor compressor cause a fault to occur straight away? Example - when everybody else's compressor failed did the system fault at the point? Is there any way for me to test the compressor. Perhaps by checking the pressure in the tank.
Edit - I've also noticed I do not have the Red Light on the dash? should I, or could this point to the problem?
Last edited by theanswers on 1st May 2015 9:25 pm. Edited 1 time in total
1st May 2015 6:48 pm
theanswers
Member Since: 30 Jun 2010
Location: Sligo/ Belfast
Posts: 244
I've another Question -
What are these cables for? I imagine they should not be like this?
Back Left - Perhaps Related?
Last edited by theanswers on 1st May 2015 10:14 pm. Edited 1 time in total
1st May 2015 9:18 pm
theanswers
Member Since: 30 Jun 2010
Location: Sligo/ Belfast
Posts: 244
Sorry for all the questions; However I have one more.
Where is the unit which controls the area surrounded by the black square?
The low range, Air Susp lights etc don't light up.
1st May 2015 10:04 pm
theanswers
Member Since: 30 Jun 2010
Location: Sligo/ Belfast
Posts: 244
Problem Fixed.
I replaced the ABS Sensor in the front left wheel. This cured all the issues! Air Susp is now working, however I do think the compressor is tired.
I have to get a relay to suit now and the 60 amp fuse for the engine bay.
Will any of the Relays from a P38 Fuse box do? I have one in the workshop.
2nd May 2015 6:34 pm
lynalldiscovery
Member Since: 22 Dec 2009
Location: Maidstone
Posts: 7274
Pretty certain the wires behind nsr wheel are std as mine has the same, but there is a small plastic cover to protect them, I did notice the wires wer rubbing on the chassis bracket as they are badly placed, so used some neoprene foam to prevent this.
2nd May 2015 7:21 pm
DN D3 Decade
Member Since: 24 Jun 2006
Location: W.London.
Posts: 2340
Well done ! ......I thought you'd be another week at least, sorting that out.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum