Member Since: 27 Jul 2014
Location: Warsaw/Toronto
Posts: 64
Need help - which EGR (L/R) needs replacing?
So I go the dreaded EGR - can't blank as it's a MY08 with DPF, AFAIK.
I was wondering if someone can help me identify which EGR it is?
Based on the Code P045 - 6C Exhaust gas recirculation B control unit, I am guessing it's the "B" Bank so left hand side. Got some results from the IIDTool - see below.
As always, thanks in advance for your suggestions.
A or 0 is right, B or 1 is left (as sitting in the car).
The left hand one is the harder one to get at. Current: Discovery 3 06MY (55 reg) HSE Auto Zambezi Silver Allisport Fast Road Intercooler, V8 Brakes, Silicone IC Hoses, EGRs Blanked, Remapped, De-Cat pipe, FBHIC
Freelander 2 2007 HSE Manual Tambora Flame
Previous: FL2 56 reg SE Manual Black (written off )
Disco 3 06 reg B7S Manual Rimini Red
Disco 2 TD5 Y reg ES Manual Blue - Chipped
Several Discovery 300 TDis
17th Feb 2015 1:22 pm
pinchy
Member Since: 27 Jul 2014
Location: Warsaw/Toronto
Posts: 64
Thanks!
Looking forward to a fun filled evening with sockets and magnetized wrenches
Have fun. Current: Discovery 3 06MY (55 reg) HSE Auto Zambezi Silver Allisport Fast Road Intercooler, V8 Brakes, Silicone IC Hoses, EGRs Blanked, Remapped, De-Cat pipe, FBHIC
Freelander 2 2007 HSE Manual Tambora Flame
Previous: FL2 56 reg SE Manual Black (written off )
Disco 3 06 reg B7S Manual Rimini Red
Disco 2 TD5 Y reg ES Manual Blue - Chipped
Several Discovery 300 TDis
17th Feb 2015 5:23 pm
pinchy
Member Since: 27 Jul 2014
Location: Warsaw/Toronto
Posts: 64
Should I go for a OM or replacement such as Valeo/Britpart for this?
J.
17th Feb 2015 6:13 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20804
OEM valves are exactly what you would receive in a box from LR My D3 Build Thread
Member Since: 27 Jul 2014
Location: Warsaw/Toronto
Posts: 64
So I've finally found some time to dig in and replace the EGR. All went well until one of the long bolts decided to travel downward in the engine bay. I've removed the skidplates, hoping that it ended up there...it didn't, so the search continues, if need be I'll go with two bolts to LR to pickup a spare
While I wait for the sun to rise again, is there anyways to clean the gunk from these parts? (see pic below) More importantly should I?
28th Feb 2015 6:46 pm
pinchy
Member Since: 27 Jul 2014
Location: Warsaw/Toronto
Posts: 64
some searching and I think I found the answers to my question
Member Since: 27 Jul 2014
Location: Warsaw/Toronto
Posts: 64
Thanks - I'll have to reach in with my hand. Magnetic tool is useless unless you point it right where it needs to go, otherwise it sticks to the block.
1st Mar 2015 12:26 am
pinchy
Member Since: 27 Jul 2014
Location: Warsaw/Toronto
Posts: 64
After many hours and two replaced bolts - the original two went MIA during assembly - I managed to put everything together.
Not all is right yet:
- Unfortunatley I'm still getting ESF on the display
- I've got the following error in "pending" using the IIDT:
(Engine TDV6
P0407-21 (25) Exhaust gas recirculation sensor B circuit low - General signal failure - signal amplitude<minimum)
- No check engine light
- Car seems to run OK
- EGR's performing OK.
Any thoughts?
1st Mar 2015 6:53 pm
MCT
Member Since: 22 Jan 2021
Location: Bucks
Posts: 5
What diagnostic software are those screenshots from?
It looks like its iphone based and I'm looking for a LR specific diagnostic software for my 2015 LR D4 (SDv6).
If anyone can recommend something it would be appreciated.
Thanks.
22nd Jan 2021 7:14 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10622
It’s from a gap iid bt
Around £500
But does everything
22nd Jan 2021 7:24 pm
MCT
Member Since: 22 Jan 2021
Location: Bucks
Posts: 5
Thank you, I shall look into it.
22nd Jan 2021 9:27 pm
Mickw
Member Since: 07 Feb 2021
Location: Chesterfield
Posts: 3
Removal Of EGR valve.
I am thinking of blanking off both egrs is it recommended what are the pros and cons it’s a 08 discovery 3 130.00 miles on the clock thanks for your help
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum