Member Since: 01 Jan 2014
Location: Dumfries, Scotland
Posts: 84
Lacks Power when pulling hard
Car feels down on power when pulling up hills. On a road I drive often I found I had to be a gear lower to make the same progress as she used to do. Runs out of steam at just over 3000rpm in 4th and 5th gear. Pulling up a hill I regularly go up the car will sit a 70 mph but you foot is to the floor, before you flew up the hill and would do 80-90 up it no problem, just exercising the turbo officer . Sees hills now in 6th gear it would normally manage.
2 tanks of different fuel and cleaner put through vehicle.
Turbo rod moves freely. 233kpa max boost OK ??
No black smoke.
No bongs of doom or fault codes.
Runs fine and plenty of go around town and up to 65mph.
Bearmach fuel and air filters fitted 4 months ago. Any problems with them ??
Fuel from tank pump sprays about 3/4 inch above valve. (could still be blocked filter or mesh under load)
MAF and MAP readings look normal .
Going to replace fuel filter with Delphi, if still the same will drop tank, clean mesh and replace pump with Peugeot item from fleabay. Prices vary from £19.99 up to £94.00 for same thing .Advanced Factors no longer do them as they had a batch of faulty ones and hassle.
Can anybody point me in the direction of one you have used successfully and still going. Don't want to pay £94 for one that is valued at £20 or pay £20 for one that lasts a week. When tank out might as well replace pump as it has 90000 miles on clock and that should be one less item to fail
20th Jan 2015 5:05 pm
Alan B
Member Since: 12 Feb 2013
Location: Fife
Posts: 6528
Just a thought,
Is the intercooler hose okay?
Ignore me if that's idiotic
D3 57 xs Stornaway grey
D2 02 commercial silver gone but a great servant and won't be forgotten
Iid Bluetooth
20th Jan 2015 5:35 pm
scaniaman
Member Since: 01 Jan 2014
Location: Dumfries, Scotland
Posts: 84
No black smoke and pulls well till 3000rpm, boosts to 233kpa, checked top hose Ok, silicone hoses fitted last year. Would love to have found a hole but don't think so due to lack of black reek.
20th Jan 2015 6:05 pm
lynalldiscovery
Member Since: 22 Dec 2009
Location: Maidstone
Posts: 7274
Map sensor top of plastic trunking, theres a thread on it somewhere titled check your map sensor now.
20th Jan 2015 6:52 pm
Allan_T
Member Since: 10 Sep 2012
Location: Northampton
Posts: 1034
What are your MAF and MAP readings at wide open throttle? A pressure reading from the low pressure fuel line would provide a direction for subsequent tests.GAP IID Pro Multi Vehicle Defender L316 2007-2015 - Discovery 3 - Discovery 4 - Discovery Sport L550 - Freelander 2 - Range Rover Evoque L538 - Range Rover L322 - Range Rover L405 - Range Rover Sport L320 - Range Rover Sport L494 Electrical Fault Diagnostics
20th Jan 2015 7:21 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20795
IMHO, if you are going down that route, pay the £300, and get an OEM unit, complete
Replaced 1 pump myself, which failed after 3 weeks, and also replaced another 2, an Ebay special, and one from ECP. Not worth the hassle...
Need to know what the MAF/MAP + boost temps are, both at idle and under load My D3 Build Thread
Member Since: 29 Jan 2013
Location: Aberdeenshire
Posts: 2294
I felt mine at 112,000 miles was suffering pull upper range, the new turbo is loosing off and the torque I now have is huge improvement, just wear and tear I suppose, not done my fuel pump yet, did talk with Mike about it but getting I think good low pressure feed at the top bleed, Mike that correct???FFRR SC 4.2
Member Since: 01 Jan 2014
Location: Dumfries, Scotland
Posts: 84
maf at idle 17.5 to 19.5 g/s Map at idle 99.00 kpa boost temp ?
At hill 4th gear 3623rpm 100% Load maf 173 g/s map 208kpa
At hill 5th gear 2397 rpm 100% load maf 128g/s map 230 kpa
Never looked at boost temp will look next chance I get.
If turbo U/S would boost pressure not be down as its using the air quicker than the turbo can supply it, fairly constant on hill between 226 and 230kpa. what should max boost be? Pulls well from 1500rpm, takes off at just below 2000rpm just not happy under load.
Car used to dig in going up hill, give it a bit extra throttle at bottom then have to lift off half way up as speed increased, now flat to floor to keep original speed
Still think it fuel followed SWMBO when she was driving up the hill and no black smoke at all.
20th Jan 2015 8:54 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20795
You can check the fuel rail pressure readings.
Though if it was lack of fuel, I would expect an ESF warning...My D3 Build Thread
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum