Member Since: 01 Jun 2014
Location: Sutton Coldfield
Posts: 59
Same old story ....SUSPENTION FAULT
please help I've had my d3 plugged in on a new snap on diagnostic machine if it makes any difference the fault was front right hand corner valve so I replaced it with a genuine new one ... Run the car clear codes and it still says normal ride hight only and when plugged in it still says front right corner valve still, can some body tell me where to start looking now the right corner does feel like it's got a weak shock if this makes any difference .... Please guys HELPPPP! After many faults I'm now looking at a petrol can and a box of matches ... thing..
14th Jun 2014 8:35 am
grzesiul
Member Since: 11 May 2008
Location: UK
Posts: 6335
what code were you getting on the check?
G
14th Jun 2014 8:43 am
Tosspot
Member Since: 01 Jun 2014
Location: Sutton Coldfield
Posts: 59
Hi the code is the same both times C1A32 front right corner valve.. thanks for the reply
14th Jun 2014 9:26 am
grzesiul
Member Since: 11 May 2008
Location: UK
Posts: 6335
according to the workshop man it might be caused by one of the following:
Right-hand front corner valve, general electrical failure --swapped so eliminated
Front valve block disconnected
Front valve block harness wiring short circuit to ground or high resistance
Right-hand front corner valve failure
Air suspension control module failure
good luck hunting it down
14th Jun 2014 10:03 am
Tosspot
Member Since: 01 Jun 2014
Location: Sutton Coldfield
Posts: 59
Thank you very much that gives me a direction to start looking .. I might being asking for more help if you don't mind ))
14th Jun 2014 10:28 am
grzesiul
Member Since: 11 May 2008
Location: UK
Posts: 6335
check your PM and let me know
G
14th Jun 2014 10:42 am
SpiderBaby D3 Decade
Member Since: 21 Sep 2007
Location: Liverpool
Posts: 1409
Have you checked the three wiring blocks behind the NSF wheel arch liner?
They can be prone to corrosion and cause some suspension faults.I see no ships........
14th Jun 2014 10:43 am
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20829
Member Since: 01 Jun 2014
Location: Sutton Coldfield
Posts: 59
I know this sound but where abouts behind arch ? Cheers
14th Jun 2014 12:05 pm
Tosspot
Member Since: 01 Jun 2014
Location: Sutton Coldfield
Posts: 59
You know I love this site..... only wished I had joined earlier it might have saved me 3 bouts of depression.. turning to drink and the need to kick the dog every time I hear a ping ping .. Anther fault
14th Jun 2014 12:08 pm
grzesiul
Member Since: 11 May 2008
Location: UK
Posts: 6335
...it should be with you ...
G
14th Jun 2014 12:57 pm
grzesiul
Member Since: 11 May 2008
Location: UK
Posts: 6335
to get to the mentioned wires you'd need to remove plastic wheel arch lining after you have removed outer plastic wheel arch 10 min job
G
14th Jun 2014 12:58 pm
SpiderBaby D3 Decade
Member Since: 21 Sep 2007
Location: Liverpool
Posts: 1409
Here's a picture (courtesy of the incomparable Pete Bell) showing the connectors in the NSF arch
I see no ships........
14th Jun 2014 2:17 pm
Tosspot
Member Since: 01 Jun 2014
Location: Sutton Coldfield
Posts: 59
Anther big thanks for the pics and the Manuel guys this place is becoming a sanctuary ... And I keep thinking about is the other problems I have been battling with and knocking wheels when I reverse backwards with the steering turned tight .... But 1 problem at a time thanks again guys I will post my results for the suspension ... chances are I can't sort it ...so In the words of arnold Schwarzenegger I WILL BE BACK
14th Jun 2014 5:55 pm
grzesiul
Member Since: 11 May 2008
Location: UK
Posts: 6335
good luck you will get it eventually just try look at it calmly...
G
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
please help I've had my d3 plugged in on a new snap on diagnostic machine if it makes any difference the fault was front right hand corner valve so I replaced it with a genuine new one ... Run the car clear codes and it still says normal ride hight only and when plugged in it still says front right corner valve still, can some body tell me where to start looking now the right corner does feel like it's got a weak shock if this makes any difference .... Please guys HELPPPP! After many faults I'm now looking at a petrol can and a box of matches ... 
thing..
))
