Member Since: 03 Oct 2005
Location: The Toon
Posts: 698
put a bit of copper slip on and you can use your fingers.Arctic Frost Discovery 3 TDV6 SE, Active Rear Diff, Adaptive Head Lights, Tow Pack, Ebony Leather, Roof Rails, Mantec Guard. Tasmod Stainless Sill plates. Grabber AT's. Home made mud flaps. Side Steps back on until the next time.
17th Jul 2007 7:11 pm
DN D3 Decade
Member Since: 24 Jun 2006
Location: W.London.
Posts: 2317
To get them to pull upwards without bursting a vessel, spray some wd40 down them, I used some cord to pull them up, then when the light unit is off pull the sliders out completely and do like suggested, copperslip or grease on them before putting them back.
17th Jul 2007 11:07 pm
SN
Member Since: 03 Jan 2006
Location: Romiley
Posts: 13710
I place the flat blade of a large-ish screwdriver under the tab (at 90 degrees sideways) and pull upwards using two hands down near the blade whilst keeping a thumb on the top of tab - you can stuff a thin piece of wood under it to gently lever against tooSteve N | 21MY Defender | 08MY Discovery 3 (history) | 06MY Discovery 3 (ancient history)
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum