Member Since: 06 Feb 2007
Location: Liege
Posts: 29
Front bearings
Hello everybody, does anybody have a "how to do" to change front wheel bearings ( workshop manual ) ?
11th Jul 2011 9:28 pm
chrisbowler
Member Since: 30 Jan 2009
Location: UK WALES
Posts: 176
Remove road wheel ands secure vehicle on axle stand
Undo large nut in centre of hub
Remover brake caliper and pads.
Remove pads carrier
Remove brake disc.
For security remove ABS sensor and placve well out of way
On the rear of the hub assembly there are 4 botls that hold hub to knuckle - undo all four bolts and then tap ( hard) the hub away from the knuckle. This may take some effort as the hub will be tight on the knuckle and on the drive shaft.
Wkps manual suggests using a special tool to push drive shaft into the hub but I have found that with lots of wd40 and some ( heavy ) tapping, they usually come free.
Re assemble the whole lot but remember to make sure the centre hub nut is do up well
Chris BowlerChris Bowler
D3 2005 EXPEDITION
D2 Challenge Vehicle
300 TDi Spare car
107" TD5 Comp Safari Motor
11th Jul 2011 11:08 pm
djcleckie
Member Since: 08 Feb 2010
Location: Highlands
Posts: 189
Hi
There is a thread running on this issue.
http://www.disco3.co.uk/forum/topic67354.html2005 SE Manual Cairns Blue
Faultmate MSV2
Series 2 - long gone
RR Classic long gone.
Disco1 believe its still going as a farm vehicle in France.
11th Jul 2011 11:36 pm
mardax
Member Since: 06 Feb 2007
Location: Liege
Posts: 29
Thank you everybody, work will begin this morning, i will try to make a "how to" with pics
16th Jul 2011 7:52 am
mardax
Member Since: 06 Feb 2007
Location: Liege
Posts: 29
Does anybody have torque specifications ?
16th Jul 2011 8:13 am
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20732
IIRC, caliper carrier bolts are 275Nm, hub nut is 240Nm, and wheel nuts are 140-145Nm My D3 Build Thread
Member Since: 29 Nov 2010
Location: West Sussex
Posts: 151
In the July issue of Land Rover Owner international there is a step by step guide for this - with pictures. it refers to the fitting of a new driveshaft nut tightened to 230Nm.
If you want me to scan it and e-mail it to you, pm me.
16th Jul 2011 12:08 pm
mardax
Member Since: 06 Feb 2007
Location: Liege
Posts: 29
<thank you everybody, it took me 2h1/2, many pictures and made a toll to pull the hub
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum