Advertise on DISCO3.CO.UK
Forum · Gallery · Wiki · Shop · Sponsors
DISCO3.CO.UK > Technical (D4)

Air compressor problem
Post Reply  Down to end
Page 1 of 2 12>
shirra
 


Member Since: 05 Oct 2022
Location: Hässleholm
Posts: 38

Sweden 2012 Discovery 4 3.0 SDV6 HSE Auto Unknown ColourDiscovery 4
Air compressor problem

Hi everybody
just replaced my hitachi compressor to a AMK one. this was because i got the yellow warning on my dash saying suspension fault. the car couldnt raise itself from the bottom and i thought obvious problem was the compressor.
so my mechanic replaced BUT it still doesnt work. Voltage and current is going to the compressor and relay but they can figure out why the heck the car isnt raising, the searced for fault codes but couldnt find any linked to the suspension

they found these however:

C1B00
U3000
B1081
B1082
P0562
U0300
B1A00
U2003


So now my attempt will be to hard reset the car and hope for the best.

Does anyone have any suggestion?????
  
Post #235002610th Oct 2023 2:14 pm
View user's profile Send private message View poster's gallery Reply with quote
shirra
 


Member Since: 05 Oct 2022
Location: Hässleholm
Posts: 38

Sweden 2012 Discovery 4 3.0 SDV6 HSE Auto Unknown ColourDiscovery 4

The hard reset didn't helt anything.
  
Post #235003510th Oct 2023 3:34 pm
View user's profile Send private message View poster's gallery Reply with quote
PROFSR G
 


Member Since: 06 Mar 2017
Location: Lost
Posts: 4658

Ukraine 2009 Discovery 3 TDV6 Commercial XS Auto Stornoway GreyDiscovery 3

Battery voltage?
 yµ (idµ - eAµ) ψ=mψ

 
 
Post #235005810th Oct 2023 5:59 pm
View user's profile Send private message View poster's gallery Reply with quote
shirra
 


Member Since: 05 Oct 2022
Location: Hässleholm
Posts: 38

Sweden 2012 Discovery 4 3.0 SDV6 HSE Auto Unknown ColourDiscovery 4

The usual 14.something volts
  
Post #235006210th Oct 2023 6:39 pm
View user's profile Send private message View poster's gallery Reply with quote
shirra
 


Member Since: 05 Oct 2022
Location: Hässleholm
Posts: 38

Sweden 2012 Discovery 4 3.0 SDV6 HSE Auto Unknown ColourDiscovery 4

The yellow triangle warning shows up about 5 seconds after the engine is started
  
Post #235006610th Oct 2023 7:05 pm
View user's profile Send private message View poster's gallery Reply with quote
PROFSR G
 


Member Since: 06 Mar 2017
Location: Lost
Posts: 4658

Ukraine 2009 Discovery 3 TDV6 Commercial XS Auto Stornoway GreyDiscovery 3

Based on what you have posted it sounds like you have a major air leak. The compressor is struggling to keep up with the leak hence it overheats. That's really bad for the compressors life span!
 yµ (idµ - eAµ) ψ=mψ

 
 
Post #235007610th Oct 2023 8:21 pm
View user's profile Send private message View poster's gallery Reply with quote
shirra
 


Member Since: 05 Oct 2022
Location: Hässleholm
Posts: 38

Sweden 2012 Discovery 4 3.0 SDV6 HSE Auto Unknown ColourDiscovery 4

The problem is that the compressor isn't even working.
And it's brand new.
I get the fault code directly when engine I started.
Could it be the center valve block.
The front is replaced this summer
  
Post #235007810th Oct 2023 8:35 pm
View user's profile Send private message View poster's gallery Reply with quote
PROFSR G
 


Member Since: 06 Mar 2017
Location: Lost
Posts: 4658

Ukraine 2009 Discovery 3 TDV6 Commercial XS Auto Stornoway GreyDiscovery 3

No. You posted earlier the old compressor is now behaving as badly as the new one. This leads me to think its installed incorrectly?
 yµ (idµ - eAµ) ψ=mψ

 
 
Post #235007910th Oct 2023 8:43 pm
View user's profile Send private message View poster's gallery Reply with quote
shirra
 


Member Since: 05 Oct 2022
Location: Hässleholm
Posts: 38

Sweden 2012 Discovery 4 3.0 SDV6 HSE Auto Unknown ColourDiscovery 4

It's installed correctly since I got a chance to inspect it myself.
The new compressor an amk instead of hitachi.
Could it be that the rear valve block I bad.
Since its totally saggy in the rear and almost saggy in the front.
And everytime i open the car with the key fob I hear a weird notice from the rear like a valve sort off releases gas
  
Post #235008110th Oct 2023 9:31 pm
View user's profile Send private message View poster's gallery Reply with quote
PROFSR G
 


Member Since: 06 Mar 2017
Location: Lost
Posts: 4658

Ukraine 2009 Discovery 3 TDV6 Commercial XS Auto Stornoway GreyDiscovery 3

It's possible that coincidentally you have a major valve block failure as well but it would be unusual. In any case there should be fault codes to support that theory, but then there should be fault codes for whatever is happening generally with the suspension. My feeling based on your post is that there is a major air leak somewhere!
 yµ (idµ - eAµ) ψ=mψ

 
 
Post #235008610th Oct 2023 10:11 pm
View user's profile Send private message View poster's gallery Reply with quote
shirra
 


Member Since: 05 Oct 2022
Location: Hässleholm
Posts: 38

Sweden 2012 Discovery 4 3.0 SDV6 HSE Auto Unknown ColourDiscovery 4

I agree with above.
Major air leak and I'm gonna order a rear valve block and center valve block.
The front valve block is replaced and tested for leak when I installed it myself.
This is is only getting more expensive lol.

I seriously can't think of anything else.
  
Post #235008710th Oct 2023 10:19 pm
View user's profile Send private message View poster's gallery Reply with quote
PROFSR G
 


Member Since: 06 Mar 2017
Location: Lost
Posts: 4658

Ukraine 2009 Discovery 3 TDV6 Commercial XS Auto Stornoway GreyDiscovery 3

Well check it first!! There's no point firing the parts cannon without confirming the fault. If there's a major leak the suspension will not be able to rise, and it should be very easy to locate the cause as there will be air gushing out of it!
 yµ (idµ - eAµ) ψ=mψ

 
 
Post #235008910th Oct 2023 10:35 pm
View user's profile Send private message View poster's gallery Reply with quote
shirra
 


Member Since: 05 Oct 2022
Location: Hässleholm
Posts: 38

Sweden 2012 Discovery 4 3.0 SDV6 HSE Auto Unknown ColourDiscovery 4

I will check but don't know how since both the front and rear suspension are at the bottom....
  
Post #235009411th Oct 2023 4:13 am
View user's profile Send private message View poster's gallery Reply with quote
shirra
 


Member Since: 05 Oct 2022
Location: Hässleholm
Posts: 38

Sweden 2012 Discovery 4 3.0 SDV6 HSE Auto Unknown ColourDiscovery 4

I went out and checked the rear valve block and rear dampers, sprayed som water and soap and couldnt find any leaks, but then again the car is at the absolute bottom.
I could hear the compressor working for a couple of seconds before the fault came up on the dash, im almost sure its a leak and im suspecting the center valveblock.
i have tested the fuses and they are alright. all of them.
  
Post #235010311th Oct 2023 8:44 am
View user's profile Send private message View poster's gallery Reply with quote
shirra
 


Member Since: 05 Oct 2022
Location: Hässleholm
Posts: 38

Sweden 2012 Discovery 4 3.0 SDV6 HSE Auto Unknown ColourDiscovery 4

Just a quick question
Does the air compressor send air to the air tank or the dampers first
  
Post #235025913th Oct 2023 9:58 am
View user's profile Send private message View poster's gallery Reply with quote
Display posts from the last:  
Post Reply Back to top
Page 1 of 2 12>
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO3.CO.UK is independent and not affiliated to Land Rover.
Switch to Mobile Site