Member Since: 25 Sep 2021
Location: Peterborough
Posts: 58
Drive Shaft Question - pulled out
So, a quick upper arm replacement is throwing up more issues than I ever thought possible.
Next issue, when trying to pull the knuckle forward to release the drive shaft from it, it pulled cleanly out the diff end instead.
Question 1. Can I reinsert this? - very gently, watching seals etc. Or do I need to swap anything?
Question 2. The 'joints' in the CV boots look to now be 'droopy', should these just push back into place? Or have I screwed something up and need to remove CV boots and rebuild this?
Thanks again
RichDisco 4 2012 HSE, Nara Bronze
Gone but not forgotten
2007 FreeL2 XS, Stornoway Grey
9th Jul 2024 12:10 pm
Tyty
Member Since: 18 Aug 2022
Location: South West
Posts: 77
I did the exact same thing and pulled the half shaft out the diff, slid it back in and havent had any other issues. To remove the shaft from the knuckle I ended up using a puller to push the shaft through. Used plenty of copper grease when putting it back together as it was very tight
No comment on the droopy boots
9th Jul 2024 12:55 pm
Rbillington
Member Since: 25 Sep 2021
Location: Peterborough
Posts: 58
Just to confirm for anyone reading this in the future, I cleaned the drive shaft, and carefully reinserted it and all is well.
Will do a diff oil swap shortly to make sure its clean and happy inside.
Also, it took a lot of WD40 and a 15t hydraulic gear puller to push the drive shaft out of the wheel bearing (12 years of rust I guess)Disco 4 2012 HSE, Nara Bronze
Gone but not forgotten
2007 FreeL2 XS, Stornoway Grey
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
