Member Since: 24 Sep 2020
Location: Leeds
Posts: 4
New Clutch and Flywheel, 2.7tdi manual
Hi, I'm having my (badly slipping) clutch and flywheel replaced, should I replace XY sensor at the same time?
Many thanks in advance,
David
24th Jan 2022 10:24 am
latnutgub
Member Since: 25 Aug 2011
Location: Huddersfield
Posts: 170
Hi, the XY sensor normally just needs recalibrating after a clutch slip. I changed my crankshaft position sensor when I changed the flywheel. You need Jedi skills to access that from the outside. Why do you think your XY sensor has failed?
24th Jan 2022 12:22 pm
Kilroyd
Member Since: 24 Sep 2020
Location: Leeds
Posts: 4
Hi, thanks very much for your reply
I don't know that the XY sensor has failed, only that my clutch is slipping v badly and i'm having a new clutch and flywheel installed. The mechanic asked if I wanted my XY sensor replacing at the same time, and I wasn't sure whether to (£240 Inc vat).
Thanks again,
David
24th Jan 2022 12:25 pm
latnutgub
Member Since: 25 Aug 2011
Location: Huddersfield
Posts: 170
Its worth looking at search Manual Gearbox XYZ Sensor Failures
I have just finished a clutch renewal mainly because the DMF was defective.
My D3 is 14 years old so when I had access to the CPS which is behind the DMF I renewed it for a new one as these things do not improve with age.
The DMF also needs 8 new bolts for correct fitting.
Has your mechanic said anything about any fault codes prior to taking the Gbox out?
Personally I would not renew it, unless he broke it taking the box off.
The top XY electrical connector is very hard to see from below.
As an option you could get the complete Gbox with XY sensor for £150
Member Since: 24 Sep 2020
Location: Leeds
Posts: 4
Hi, he hasn't got the vehicle yet so he hasn't read any fault codes.
I had the park brake auto release warning a few weeks ago and reconfigured my XY sensor, which fixed it. Same happened again but reconfig' wouldn't work, clutch then started slipping every gear and wouldn't stall, in any gear, with engine running when stationary (foot off clutch).
Described to mechanic and he suggested most likely clutch / DMF, so booked in to do that work tomorrow.
Many thanks again.
24th Jan 2022 1:14 pm
latnutgub
Member Since: 25 Aug 2011
Location: Huddersfield
Posts: 170
Your mechanic is saying the right things. The clutch slipping will throw the calibration out on the XY sensor.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
