Richie011
Member Since: 19 Jan 2018
Location: Elgin
Posts: 2
|
HELP!!! While driving rotational knocking noise. |
|
Hi folks I'm needing a wee bit of help please.
My D3 had a worn centre bearing on the prop. I started to find I was getting a knocking noise while driving and if I gave it some gas it would turn from a knock to a loud thudding! If you keep the speed steady it would return to just a rotational knocking. So I changed the centre bearing thinking this will fix the problem BUT NO!!! It's like it's trying to get into low drive or like the diff on the front is packing in (I hope not).
Anyone got any magic dust left???
|
19th Jan 2018 10:24 pm |
|
|
Randylover
Member Since: 31 Jan 2011
Location: Staffordshire
Posts: 1172
|
Mines doing similar,
My Dual Mass Flywheel is on its last legs
Andy 05 TDV6,"S" in all colourcoded Zermatt silver,7 seats winter pack HK 6cd stereo,Dual climate,Xenons,
Mods:
Re-Con Engine,De-Tango,Reverse camera,Fog/DRl lights,Aux Battery, perm Aux socket in boot,LED Volt meters in roof panel,Built in tom tom, Strobes fitted in grille, Aux switches for trailer lights fitted in roof panel,Roof Rails,Grille conversion
|
20th Jan 2018 10:54 am |
|
|
Richie011
Member Since: 19 Jan 2018
Location: Elgin
Posts: 2
|
I had the clutch and flywheel done last year I hope it's not that again 🙄.
I find that when I turn left the noise goes away until i have straightened up.
I'm thinking front drive shaft or wheel bearing??
|
20th Jan 2018 10:32 pm |
|
|
Globetrotter448
Member Since: 21 Mar 2017
Location: Londonderry NSW
Posts: 1791
|
When doing the centre bearing did you check the various uni joints. It has often been recommended that you replace the whole prop shaft assembly instead of just the bearing.
I would recheck
|
21st Jan 2018 5:29 am |
|
|
L319
Member Since: 14 Dec 2013
Location: Herefordshire
Posts: 2080
|
Changed my propshaft as the centre bearing was shot, but when I got it off, found the UJ was also partially seized, have you checked that end as well
|
21st Jan 2018 9:33 am |
|
|