Member Since: 23 Feb 2016
Location: North East
Posts: 136
D3 to D4 Facelift, Fitting a original D4 Grille on a D3
I am doing a D3 to D4 facelift, have finished the back end of car and working on the front. I am fitting D4 bumper, lights, wings and grille on front end.
Fitting the facelift parts all seems straight forward apart from the D4 grille, I tested and found the two bottom clips on a D4 grille are different than those on a D3 grille.
Can anyone offer advice on how to fit a original D4 grille on a D3 when doing a facelift and what modifications or parts are needed to make it fit?
Thanks
John
6th Jun 2016 9:33 pm
philby258
Member Since: 18 Apr 2012
Location: Stockport cheshire
Posts: 654
Hi John, assuming you have already fitted the D4 wings lights and bumper the grille should just push on mine did, 2 pegs at the bottom and 4 tabs at the top
6th Jun 2016 11:56 pm
Mews
Member Since: 23 Feb 2016
Location: North East
Posts: 136
Hi, No I have not yet fitted the D4 wings, bumper and lights as I just wanted to make sure I am all prepared when I do it as want to do it all in one go (before the Mrs needs the car back). So I just tested the D4 grille and noticed the top clips were fine but the 2 corner bottom clips just didnt have anything to clip into. So wanted to check before I start
So by fitting the D4 wings, bumper and lights how will this change where the D4 grille bottom clips fit into?
John
7th Jun 2016 12:10 pm
bear1009
Member Since: 12 Feb 2013
Location: aberdeen
Posts: 214
Are they not angled at the bottom corners? So you would need to fit the bumper first before it fits righttinted windows
led sidelights
new fuel pump
disco 3 sticker
4x4 screen unlocked ( thanks bell autos)
bell autos egr blanking kit
halo fog day running lights
ffrr sat nav hack
gvif reverse camera
clear side indicators
alisport intercooler hoses
7th Jun 2016 4:44 pm
philby258
Member Since: 18 Apr 2012
Location: Stockport cheshire
Posts: 654
The 2 bottom pegs locate into oval holes in the slam panel pull your D3 grille off and you should see them
9th Jun 2016 11:45 pm
Mews
Member Since: 23 Feb 2016
Location: North East
Posts: 136
I have read over a few posts and am I correct in thinking that I need to file the oval holes a bit so they are little wider and then insert the Discovery 4 front grille plastic mounting/docking inserts? The 2 bottom pegs on the D4 grill then clip into these (see image)
15th Jun 2016 4:29 pm
philby258
Member Since: 18 Apr 2012
Location: Stockport cheshire
Posts: 654
I dont recall any modification needed it just pushed in, they are tight though to make it secure.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum