| Search results - "sockets" |
80 viewsCarPC closed and ready for mounting. Note the modification to the rear of the case to allow extra USB sockets attached to the motherboard pins.
|
|
79 viewsExtra USB sockets mounted to front of commercial box, just behind cubby box
|
|
Sockets to be improved79 views
|
|
Connector sockets 8-12 & 21-2344 views
|
|
Twin 7 Pin Socket Towing Electrics Fitting Instructions264 views
|
|
Tow Electrics73 views
|
|
Amprobe 240 Test Sockets33 views
|
|
aux sockets relay - remove the relay and put in link wire 192 views
|
|
Auxiliary power sockets - TracTronics, Australia382 viewsA complete kit including two outlets, wiring etc connected to auxiliary Optima Blue top battery using their very effective SC40 split charge relay. One outlet between rear and front seats, and 2nd alongside loadspace 12v outlet, enables fridge to run when engine is not running, without affecting start capacity or vehicle functions.
|
|
LR towing electrics pack 12N/12S313 viewsThe LR trailer electrics fitted before the Kaymar bumper and spare wheel carriers required no modifications are perfectly accessible. Good strong recovery point between the sockets too. The swing awau wheel carrier securing latches can be seen quite clearly here. Long Ranger tank (painted black) nestles where orignal spare was fitted.
|
|
Thread upload5 viewsImage uploaded in new thread
|
|
Cover with 2 12V sockets, 2 USB sockets and 220V socket19 views
|
|
Additional 12V power, battery monitoring and USB sockets104 views
|
|
Everything out \'cept the sockets at the bottom \'cos they\'re a bitch581 views
|
|
New impact sockets26 views
|
|
Ceiling Sockets 138 views
|
|
Ceiling Sockets 236 views
|
|
Power sockets24 viewsI moved the two power sockets over from D3 to D4, both with ebony interior. One Merritt socket for fridge, and another standard socket for recharging devices.
|
|
Passenger Seat fitted, 8 way movement via power sockets410 views
|
|
NAS 7 Pin Round Socket + 4 Pin Flat Socket oriented as installed.752 viewsThis is the layout you see when you look into the NAS Land Rover sockets as installed at the rear of the LR3/4. The flat 4 pin socket is located under the round socket.
Wiring order is relative to the slot on the round socket, and hence the same as the other jpg where the slot is shown at the top.
The CJB monitors the front and rear turn signal lamps and can detect if more than four lamps are fitted, (the side turn signal lamps are not monitored). This is another reason for using genuine LR bulbs as off shore bulbs can have varied and out of spec resistance values.
When a trailer is detected, the trailer warning indicator in the instrument cluster is supposed to flash green in synchronization with the turn signal indicators.
If one or more of the turn signal lamps on the vehicle or the trailer are defective, the trailer warning indicator will cease to flash any longer. This is to alert the driver to probably bulb failure.
If the trailer has LED lamps installed, and no LED adapter circuitry is used, most likely the trailer will not be sensed and systems such as the backup sensors will not be disabled.
|
|
a few items being built in behind cover panel.442 viewsred inverter will have fluch mount plugs, air outloet will be flush, guage with window in lower pop-panel and switches and fuses for all rear items behind popout panel.
12v sockets being added as well, high and low.
|
|
Thread upload42 viewsImage uploaded in thread 47507
|
|
Thread upload42 viewsImage uploaded in thread 47507
|
|
Pass-through sockets55 views
|
|
NAS 7 plus 4 pin LR3 Trailer wiring, trailer end. 498 viewsThis is the LR wiring diagram showing the conductors from the the Trailer Brake Controller connector, C2590, back to the rear combo NAS 7 plus 4 pin sockets.
|
|
48 views
|
|
95 views
|
|
53 views
|
|
rear socket install1038 viewsShows to white cable run, cable routing, cable ties and socket placement. Rear sockets fitted. Note the white power cable, and cable tie location. The socket in this position are neatly back out of the way, but handy.
|
|
rear socket install838 viewsThis photo shows the rear sockets installed, shows how the sockets in use are tucked up nicely and out of the way.
|
|
rear socket installation complete643 viewsThis demonstrates the rear sockets installed, shows how the sockets in use are tucked up nicely and out of the way.
|
|
radar detector wires tucked up high426 viewsThe orange ties hold wiring sockets for floodlights (to be installed). Red tie holds excess wire for radar detector.
|
|
wires tied up tight542 viewsThe Orange ties hold wiring sockets for floodlights (to be installed). Red tie holds excess wire for radar detector.
|
|
permenant aux sockets ..place link wire here 158 views
|
|
96 views
|
|
92 views
|
|
57 views
|
|
Thread upload6 viewsImage uploaded in thread 80646
|
|
12v outlet wires859 viewsonside the drivers side rear hatch, whos the wires joined up for the rear sockets.
|
|
Thread upload10 viewsImage uploaded in new thread
|
|
Thread upload5 viewsImage uploaded in thread 186884
|
|
846 views
|
|
PS2 + Split charge system 10 viewsPS2 - Wireless controllers and headphones.
Split charge system with auxiliary sockets with digital voltage display
|
|
|
|
|
