Search results - "grommet" |
752 viewsNew control rod is carbonfibre/fibreglass hollow tube, with a rubber grommet fitted to one end (screwed and epoxy-ed) and steel rod bent into shape at the other (epoxy-ed).
|
|
comparing new grommet59 views
|
|
sunroof drain grommet - piece that broke off59 views
|
|
oil seems to be coming from grommet on auto-box80 views
|
|
solar panel install347 viewsAt least at this point, I mounted it by using Clear Silicone RTV. This stuff is kind of like glue, but can be removed. If it doesn't hold up after curing and driving, I'll remove it and come up with another plan. I used heavy cable ties on the 4 grommets, in case it lets loose, it won't take out my wiring and the car behind me. 2 Panels are dandy like this, but I don't want to permanently block the roof space. Grape Solar to power my snomaster fridge
|
|
219 views
|
|
Bulkhead grommet O/S167 views
|
|
Pin 2 grommet removed79 views
|
|
...alternative grommet threaded through (but not cut)...62 views
|
|
Grommet on bulkhead easily located...77 views
|
|
Front-right view (looking forward) of partially installed winch and mount122 viewsThe closest bracket, with three rubber grommets, is the air bag sensor. Before beginning any of this work, be sure to disconnect battery and discharge any remaining electrical power. I didn't want to accidently drop this assembly and cause the airbags to deploy.
|
|
Warn Winch gromet/retainer for Warn Winch screws197 viewsPart no. for warn winch grommet/washer for warn number plate holder
|
|
Warn Winch grommet/retainer for number plate holder240 viewsPart no. for Warn grommets for numbe rplate holder.
|
|
gas stove slides out under fridge107 viewsvery useful mod - youdon\'t have to unpack anythinig to be ready to cook. the stove gas is piped from the rear of the trailer, ie. the standard gas cylinder. pipe goes thru grommets along bodywork, and uder the fridge. works a treat. the door adds shielding in high winds if need be
|
|
102 viewsLooking for the grommet
|
|
103 viewsGrommet found behind soundproofing
|
|
106 viewsPower cables passed through grommet
|
|
Harness that connects inside left rear compartment.435 viewsThis is the harness section that connects behind the left rear interior access panel and exits thru the large grommeted hole to below/behind the left rear tail light.
Note the two rubber grommets on the harness as there is both an interior metal skin and an exterior metal skin behind the left tail light assembly.
The two light grey connectors plug into two existing connectors near the top of the rear left interior access panel. The two darker connectors plug into the second piece of harness.
There is no little separate fuse box either with the NAS spec harness. The fuse box is included with the UK 13 pin dual plug units. If there was a fuse box, it would be on this portion of the harness.
|
|
LHD grommet86 views
|
|
LHD grommet90 views
|
|
LHD grommet w/comments96 views
|
|
firewall plug run706 viewsThe rubber grommet from firewall plug, removed, with a hole cut in the middle. Instructions say to cut it to the center, but you can cut a hole out by bending it, and using a pair of diagonal pliers, removing excess material so you can fit the plug back in.
|
|
firewall plug run650 viewsThe rubber grommet from firewall plug, removed, with a hole cut in the middle. Instructions say to cut it to the center, but you can cut a hole out by bending it, and using a pair of diagonal pliers, removing excess material so you can fit the plug back in.
|
|
dead easy to get cables from boot to rear light cluster through existing grommets342 views
|
|
118 viewsThe signal wire then drops into the aux battery box and through the bulkhead grommet
|
|
Signal wire through aux battery box to grommett118 views
|
|
Thread upload0 viewsImage uploaded in thread 198799
|
|
Thread upload0 viewsImage uploaded in thread 198799
|
|
Thread upload0 viewsImage uploaded in thread 198799
|
|
|
|
|
|