| Search results - "Washer" |
The full complement of bits and pieces, major parts back from the powder coaters, all bolts nuts washers replaced with stainless steel241 views
|
|
51 viewsD44 front winch bumper. Ali washer bottle. D44 rear h/d bumper. centre diff lock. 235x85x16 pirelli muds. OME +2" springs & shocks. front diff guard. side tree bars. wired for roof CB. Aux fuse block. safari snorkel. extended wading tubes. the list goes on...
|
|
Fog Light & Washer Jet Install93 views
|
|
Fog Light & Washer Jet Install94 views
|
|
Mitsubishi Montero Headlight Washer43 views
|
|
114 viewsboth adapter the larger one needed a bit chopped off the botom and the washers to fit
|
|
182 viewscame loose when washing car with power washer - its 15" long and hollow
|
|
Washer Bottle Bracket878 views
|
|
New front bumper with headlamp washers, fogs and PDC complete110 views
|
|
Headlight washer plugs83 views
|
|
bottle with H/L washer pump and leveling sensor to the right - the space on the far right is for the w/screen pump85 views
|
|
Headlight washer hose85 views
|
|
Wipers, Front and Rear, plus Washers description and operation.818 viewsThis 17 page pdf describes how the wipers, front and rear, plus the washers are intended to operate. Also described is how the rain sensor is designed to function along with a table of the wiper delay timing parameters.
|
|
Aux Battery showing ground cable bolt "upside" down 1577 viewsIn order to obtain sufficient height clearance to get the plastic cover back on, I had to install the ground cable to the underside of the battery post connector.
Note the battery vent hose, (approx 5 ft required) is run down into where the windshield washer fluid container is located. There is not much electrical or metal in that area to be corroded by battery gas plus the open end of the vent hose tends to be protected from dirt and stays clean as well.
|
|
BCI Group 40R Deka 640RMF battery showing vent hose run forward to windshield washer reservoir area 1430 viewsRecessed post "Euro profile" battery to "match" OEM and stock Land Rover bracket; note that the Traxide SC80-LR module is mounted at an angle to allow for the main cable to sit under the cover so cover still closes.
The battery is a nominal 7", (180mm), high, but sits on a 1" battery spacer set under to raise the bottom front end of the battery such that the approx 11", (290 mm), length of the BCI 40R battery rises above the angled plastic nibs at the forward end bottom of the case front; hence sufficient space, (1/4", 5mm) remains at the brake reservoir end.
Also the 40R battery does not have hold down "flanges" on each end; on the sides yes, but not the ends so no additional length is required.
When I had to replace the 40R, this time I installed the shorter, (9.625"), taller, (7.5") Interstate BCI 47 / DIN H5 battery which eliminated the spacer on the bottom and better fit the stock LR tie down bolt lengths. Deka also has a BCI 47 / DIN H5 that would work fine as well.
|
|
64 views
|
|
Thread upload1 viewsImage uploaded in thread 198799
|
|
Thread upload1 viewsImage uploaded in thread 198799
|
|
56 views
|
|
D3 Wipers and Washers25 views
|
|
Thread upload1 viewsImage uploaded in thread 149337
|
|
Different Llams knob c/w large washer102 views
|
|
Thread upload2 viewsImage uploaded in thread 159579
|
|
Heated Washer Jets Offside25 views
|
|
Heated Washer Jets Nearside25 views
|
|
Front bumper view of semi-installed winch121 viewsNote the left-side (looking forward) bracket holding the white windscreen washer bottle.
|
|
432 viewsWasher bottle guard, I covered the exposed headlight waser hose with protective tubing.
|
|
Warn Winch gromet/retainer for Warn Winch screws199 viewsPart no. for warn winch grommet/washer for warn number plate holder
|
|
411 viewsID of washer fuse and fuse "pincer" tool
|
|
Retro fitted Headlamp Washer Relay Rewiring Circuit Diagram301 views
|
|
26 views
|
|
22 views
|
|
7 views
|
|
screw and washer29 views
|
|
1680 viewsBracket that holds the washer bottel in now that the bumper has gone.
|
|
23 views
|
|
View of mounted panel from front left corner737 viewsI drilled a hole for the supplied 6 mm tie down toggle bolt in a flat portion of the wing on which the panel sits. I inserted a 50 mm flat rubber washer between the wing metal surface and the underside of the black painted panel plate; also a 40 mm flat rubber washer between the supplied fender washer and the metal plate - just seemed like a good idea so surfaces mate well even if wing metal not completely flat.
|
|
Mirror shell replaced - notice self tapping screws52 viewsMirror shell replaced - notice self tapping screws to replace "plastic rivet heads" and also washers on inner screw to prevent screw piercing mirror housing due to short hole.
|
|
ZF 6HP26 transmission fluid drain and refill procedure4040 viewsThis is the Land Rover instruction pdf and I note they have it right - that is remove the filler plug first, then the drain plug. Also before you attempt that, not only do you need oil, but also new fill and drain plugs as the sealing washers are deemed single use only.
|
|
Used Original holes and 3 self tappers extra with penny washers 62 views
|
|
New cut out and strength washers glued191 views
|
|
warn winch controller installation613 viewsremotely installed due to space limitations, and to keep the unit dry. Left Hand Drive, fitted in engine bay near washer fluid fill for reference point.
|
|
warn winch controller installation544 viewsremotely installed due to space limitations, and to keep the unit dry. Left Hand Drive, fitted in engine bay near washer fluid fill for reference point.
|
|
warn winch controller installation568 viewsLeft Hand Drive, fitted in engine bay near washer fluid fill for reference point.Remote control unit fitted on the box. Remotely installed due to space limitations, and to keep the unit dry.
https://www.facebook.com/DifferentialPartsUS
|
|
Sprinter Jack Mod60 viewsWasher fixing mod
|
|
Sprinter Jack mOD48 viewsWasher fixing mod
|
|
Sprinter Jack Mod46 viewsWasher fixing mod
|
|
Thread upload6 viewsImage uploaded in thread 151737
|
|
Thread upload7 viewsImage uploaded in thread 144363
|
|
Thread upload6 viewsImage uploaded in thread 133040
|
|
371 views
|
|
Thread upload5 viewsImage uploaded in new thread
|
|
Thread upload2 viewsImage uploaded in new thread
|
|
49 views
|
|
Headlight washer pipe connector60 views
|
|
Thread upload22 viewsImage uploaded in thread 107122
|
|
28 views
|
|
28 views
|
|
wipers and washers88 views
|
|
wipersandwashers168 views
|
|
|
|
