Forum · Gallery · Wiki · Shop · Sponsors


Search results - "Traxide"
20110507_0018.jpg
110 viewsBolts through the plastic box. These function as studs for the traxide brain to be mounted to.
20110507_0019.jpg
132 viewsTraxide SC80 brain modified. Cut the studs down to the nuts and removed the rubber cover. Had to do this as otherwise it wouldn't fit comfortably and would squash the brake vacuum pipe
20110507_0020.jpg
122 viewsTraxide brain mounted. It's mounted slightly tilted towards the front of the engine bay so as to give as much space as possible to the brake vacuum pipe behind it.
20110507_0025.jpg
120 viewsModified aux battery box cover with shape of battery to battery cable. I also removed the tab which was fouling my traxide brain mounting bolts.
20110528_0072.jpg
97 viewsDeciding on a layout for the electrical stuff. Bottom right of pic is a fusebox which will take the input power from the traxide kit, then relay box and 12V regulator, ignition busbar and homemade regulated 12V busbar. Big black box is the CarPC
20150327_172457-s.jpg
Deka 9A49 AGM Intimidator327 viewsThe Deka 9A49 AGM Intimidator makes an excellent primary battery alternative to the factory or Interstate. Made in US of premium quality. This is an excellent match with the Traxide system w/another Deka or Yellow Top optima.

This will behave properly in your D3/4 LR3 with slightly less wear and tear on your alternator.
20150415_144753.jpg
Traxide USI-160 Install515 viewsOverview picture of Traxide USI-160 upgrade install. This was an upgrade from the SC80 which performed flawlessly. The USI-160 had two relays and can deliver more amperage. As a result, the wiring was upgraded to 4/0 Welding Cable (warn) and heat shielding was added. The unit performs flawlessly to support 2 HAM Radios, Fridge, etc. Like me https://www.facebook.com/DifferentialPartsUS
20180603_115201.jpg
Traxide System4 views
Aux Battery vent 8.jpg
BCI Group 40R Deka 640RMF battery showing vent hose run forward to windshield washer reservoir area 1430 viewsRecessed post "Euro profile" battery to "match" OEM and stock Land Rover bracket; note that the Traxide SC80-LR module is mounted at an angle to allow for the main cable to sit under the cover so cover still closes.
The battery is a nominal 7", (180mm), high, but sits on a 1" battery spacer set under to raise the bottom front end of the battery such that the approx 11", (290 mm), length of the BCI 40R battery rises above the angled plastic nibs at the forward end bottom of the case front; hence sufficient space, (1/4", 5mm) remains at the brake reservoir end.

Also the 40R battery does not have hold down "flanges" on each end; on the sides yes, but not the ends so no additional length is required.

When I had to replace the 40R, this time I installed the shorter, (9.625"), taller, (7.5") Interstate BCI 47 / DIN H5 battery which eliminated the spacer on the bottom and better fit the stock LR tie down bolt lengths. Deka also has a BCI 47 / DIN H5 that would work fine as well.
DSC00025.JPG
Dual Battery and ECU Chip175 viewsDual Barrery System by Traxide and Optima Yellow Top battey, Plus ECU Chip being fitted
dualbatt_20110430_0027.jpg
Traxide SC-80 brain147 viewsTraxide SC-80 brain
IMAG0101.jpg
Traxide SC80-12, D4 tray and Optima D34 installed43 views
LR3 plastic cover and box back on in front of rad 0500.JPG
Plastic cover and Box back on in Front of Radiator 638 viewsThe wiring loom is below the cover - nothing is crushed or distorted and all fits back together OK. The black plastic box with the DPDT, (centre OFF), toggle switch is to tie the battery maintainer to each of the two batteries per the Traxide Dual battery install. I can also get power to the power door locks if all fails.
Main Battery showing cable around corner 0436.JPG
Main Battery showing aux cable feed running off positive battery post.776 viewsThe black wiring loom around the battery cable to the aux battery was a part provided with the Traxide kit. My goal was to run the cable low enough such that the battery box cover would go back on as previous.

Note the hole drilled in the side of the battery box such that the new cable could thread thru to allow the battery box top to still fit the same as prior to the addition of the cable to the auxiliary battery.
P1010656-s.JPG
Traxide SC80-LR657 viewsKit -- cable was 6 feet short. Check to ensure the length is adequate prior to installing it.
P1010663-s.JPG
traxide ground 677 viewsTraxide Install - Left hand drive Ground Strap in place.
P1010668-s.JPG
Traxide711 viewsLeft hand drive, primary battery with Traxide cable routed. The battery is on the right.
P1010669-s.JPG
traxide cable run742 viewsTraxide cable between primary and secondary battery.
P1010708-s.JPG
traxide808 viewsThis would be an ideal location for the traxide 80 kit, there are pre threaded holes available here.. would take a bit of fitting, and extending the cable to the primary battery would need to be extended.
P1010771-s.JPG
rear socket install1411 viewsTraxide rear socket installation, alternative location. These holes must be precisely in this location because there is little clearance to the right of left due to the blower motor and hoses, etc.
P1010776-s~0.JPG
rear socket install1038 viewsShows to white cable run, cable routing, cable ties and socket placement. Rear sockets fitted. Note the white power cable, and cable tie location. The socket in this position are neatly back out of the way, but handy.
P1010777-s.JPG
rear socket install838 viewsThis photo shows the rear sockets installed, shows how the sockets in use are tucked up nicely and out of the way.
P1010778-s.JPG
rear socket installation complete643 viewsThis demonstrates the rear sockets installed, shows how the sockets in use are tucked up nicely and out of the way.
P1010779-s.JPG
rear socket installation complete680 viewsdemonstrate a neat and roomy install
P1010782-s.JPG
DIII LR3 1441 viewsFitted Accessories
Devon 44 hidden winch
Warn XD9000 with remote kit
Safari Snorkel
Rover Specialties Rock Sliders with side nerf bars.

Yellow Top 2nd Battery

Available from --
http://www.lucky8llc.com/Products.aspx?ProductID=7136

Traxide SC80-LR D3 Kit B -TPSE

Available from --
http://www.traxide.com.au/Traxide.html
P1010794-s.JPG
Traxide SC80-LR mounted713 viewsIn this position it fits properly without stress or stretching the plastic. A single small bolt holds it securely in place, and not toughing or rubbing on wires or suspension air lines.
P1010795-s.JPG
Traxide SC80-LR mounted598 viewsA close up showing the angle, mounting bolt. Only a single top bolt can be used, there are metal lines behind the lower bolt hole.
P1010796-s.JPG
Traxide SC80-LR mounted568 viewsAnother view of the mounted unit.
P1010801-s.JPG
2005 LR3168 viewsSafari Snorkel, D44 Discrete winch, Warn XD9000, Traxide SC80, Yellow Top, Tactical Rover Sliders, GNV Rods, Engel, KN Filter, 99% Royal Purple, ZF Metal Transmission pan, Tint.
P1030961_1024.jpg
Traxide installation - rear cable20 views
thumb_IMG_3068_1024.jpg
Traxide - 2nd battery19 views
Traxide.jpg
Thread upload4 viewsImage uploaded in new thread
TRAXIDE.jpg
Thread upload5 viewsImage uploaded in thread 186405
Traxide_160.jpg
Thread upload9 viewsImage uploaded in new thread
Traxide_SC-40.pdf
Traxide_SC-40.pdf23 views
 
35 files on 1 page(s)