Forum · Gallery · Wiki · Shop · Sponsors


Home > Member Galleries > Snafu4wd

Last additions - Snafu4wd's Gallery
Arb_Compressor_DSC00569.JPG
Thread upload47 viewsImage uploaded in thread 4118725 Feb 2015
D3-FtLocker~0.JPG
Thread upload32 viewsImage uploaded in thread 4118725 Feb 2015
D3-FrontLocker.JPG
ARB Front Locker in Disco3111 viewsA bit of a challenge for the installer since it was the first they had done but all done and nice and tidy.11 Apr 2013
D3-FtLocker.JPG
ARB Front Locker in Disco3117 viewsA bit of a challenge for the installer since it was the first they had done but all done and nice and tidy.11 Apr 2013
DSC00116.JPG
GOE Bash Plates117 viewsGreen Oval Experience Bash Plates. Front, Transmission and Compressor.
Might have to mod the front one a bit to let air into the trans cooler, it sits over the outside of the ARB bar which has vents for the cooler. If I cut slots in the Allow Plate to match those might do the trick.

I added a rear bolt to the Compressor Plate as it looked like it could get hooked on something and tear off. Two bolts onto the slider and two up onto the chassis now.
11 Jan 2013
DSC00113.JPG
GOE Sliders100 viewsGreen Oval Experience Sliders11 Jan 2013
DSC00107.JPG
Ironman Drawers and Fridge Slide111 viewsI hate kitsets, over 100 bolts to assemble this unit and lost gallons of sweat, must have read the instructions a hundred times or more but final product does not look so bad. A few bolts hanging out the sides of both slide and drawers that may catch things so time will tell if I made the correct purchase.

Maybe one day I will make some side wings to cover the sides properly.
11 Jan 2013
DSC00120.JPG
Ready to Roll114 viewsCompleted putting on sliders, mud tyres etc ready for Kauri Coast 2013.
youtube.com search snafu4wd
11 Jan 2013
DSC00056Kaymar3.JPG
Kaymar Rear Bar Spare Carrier201 viewsOptional Spare tyre carrier for kaymar bar, more ground clearanve and a damned site easier to get the spare out once Dual Drawer System is put in.21 Dec 2012
DSC00031.JPG
Standard priot to Mods144 views21 Dec 2012
DSC00025.JPG
Dual Battery and ECU Chip174 viewsDual Barrery System by Traxide and Optima Yellow Top battey, Plus ECU Chip being fitted21 Dec 2012
DSC00061Full.JPG
Disco 3 - 21 December 2012163 viewsJust back from having Front & Rear Bar, Compressor and Snorkel fitted.21 Dec 2012
DSC00057Normal.JPG
Disco 3 Set to Normal Drive Height132 viewsLlams off, Normal Selected21 Dec 2012
DSC00063Plus50.JPG
Disco3 With Llams set to +50 and normal road height144 viewsAbout 50mm Lift for use with Mud Tyres21 Dec 2012
DSC00060Plus90.JPG
Disco3 with Llams set to +50mm and Offroad set148 viewsApprox 90mm lift21 Dec 2012
DSC00067-Compressor.JPG
ARB CKMTA Twin Compressor178 viewsTwin Compressor with Manifold and Airtank. Tight fit but it fits. Also the ECU Chip is at the back and below up against the battery case.

I changed the hose quick release to a standard Air Hose Fitting eg like a workshop would use. My other truck has those also.
21 Dec 2012
DSC00051Winch.JPG
KingOne 12000lb Winch124 views12000 Winch in ARB Bar21 Dec 2012
DSC00053Kaymar1.JPG
Kaymar Rear Bar123 views21 Dec 2012
DSC00055Kaymar2.JPG
Kaymar Rear Bar139 viewswith Kaymar tyre carrier21 Dec 2012
 
19 files on 1 page(s)