think4less
Member Since: 25 Nov 2008
Location: Brisbane
Posts: 10
  
|
| Wiring Route from Passenger Seat |
|
Hi, Does any one know what's the best route for wiring from passenger underseat to stereo? I opened glove box but unfortunately cannot find an exsiting wire to follow through the back of the box.
|
 30th Dec 2008 1:57 pm |
|
|
simonsi
Member Since: 14 Oct 2007
Location: Auckland
Posts: 1264
|
I went:
Forward along the door sill in the wiring channel there.
Up under the A-post kickplate.
Pull out outer dash vent panel.
feed wiring between upper and lower glovebox areas
Slightly down into the stereo rear area.
Think this should work for either-hand drive if needed by anyone else. I think. Cheers
Simon
|
| 30th Dec 2008 2:01 pm |
|
|
caverD3
Member Since: 03 Jul 2006
Location: Oberon, NSW
Posts: 6922
 
|
An easier route is just to push the cable up under the bottom of the centre console sides and then under the seat rail.  “There are only three sports: bullfighting, motor racing, and mountaineering; all the rest are merely gamesâ€
Ernest Hemmingway
D4 3.0 Active Diff, Adaptive Lights, High Beam Assist, Surround Cameras, Privacy Glass.
D3 2.7:Adaptive Headlights,Electronic Rear Diff,ARB Bar,Blaupunkt Speakers,JVC Powered Subwoofer,Removable Snorkel,Mitch Hitch,Pioneer After Market Head Unit,Steering Wheel Control Adaptor,Remote Adjustable Supension Rod System, Taxside Dual Battery System.
|
| 30th Dec 2008 10:36 pm |
|
|
think4less
Member Since: 25 Nov 2008
Location: Brisbane
Posts: 10
|
simonsi wrote:I went:
Forward along the door sill in the wiring channel there.
Up under the A-post kickplate.
Pull out outer dash vent panel.
feed wiring between upper and lower glovebox areas
Slightly down into the stereo rear area.
Think this should work for either-hand drive if needed by anyone else. I think.
Thanks for your advice, actually how can i remove the door sill and A-post kickplate? is that i just pull hard and get them off? also, how thick for the wire i can put in between the upper and lower glovebox area? i am going to put afew wiring harness plus one 8awg constant positive wire running from battery.
|
| 1st Jan 2009 11:46 am |
|
|
