lr-80
Member Since: 19 Jul 2011
Location: Oslo
Posts: 69
  
|
Have got this message in the display. Fuel filter and sensor both changed, fault code cleared but reappears immediately - probably meaning there's a wiring/connector problem. Have searched several topics here without finding where to start searching. Any ideas to help me out? 1951 Series One 80" 1600cc Deep Bronze Green
2007 Discovery 3 TDV6 HSE Tonga Green
|
 14th Sep 2011 6:51 pm |
|
|
buda
Member Since: 24 Jan 2010
Location: strathclyde
Posts: 334
 
|
I thought or read somewhere the water in fuel sensor signal was " inactive" .... someone else hopefully will shed some light on this??
|
| 14th Sep 2011 7:52 pm |
|
|
Q86ARR
Member Since: 23 Feb 2010
Location: Jersey
Posts: 378
  
|
Most likely will be corroded contacts on the fuel filter housing.
New fuel filter housing should cure it.
|
| 14th Sep 2011 9:49 pm |
|
|
Flack
Member Since: 06 Sep 2006
Location: Preston Lancashire
Posts: 6235
 
|
Agree with Q86ARR
Flack 
|
| 14th Sep 2011 9:58 pm |
|
|
lr-80
Member Since: 19 Jul 2011
Location: Oslo
Posts: 69
|
How do I check these contacts - will it be visible, perhaps temporarily cured by wd40, or will I have to change the filter housing to see if fault code reappears? 1951 Series One 80" 1600cc Deep Bronze Green
2007 Discovery 3 TDV6 HSE Tonga Green
|
| 15th Sep 2011 7:28 am |
|
|
