ostland
Member Since: 16 Jan 2009
Location: Capital!
Posts: 89
|
Washer Fluid Tube Detachment Issue |
|
Twice I had the problem of washer fluid tube becoming detached from the squirting plastic bit on the bonnet, causing the fluid to run down the back of the insulation foam. Remedy is simple enough in that you just need to slide back the tube onto the connector on the plastic, but is there a more permanent solution to this? If I use a glue would there be any problems?
|
11th Apr 2010 2:38 pm |
|
|
Andy_RS2113
Member Since: 17 Apr 2009
Location: Leicestershire
Posts: 192
|
zip tie round it to hold it on? Peter, are you drunk? No, I'm just exhaused cos I've been up all night drinking...
|
11th Apr 2010 3:39 pm |
|
|
The Transformer
Member Since: 22 Jan 2010
Location: Leicestershire
Posts: 1791
|
Is there enough slack to cut the tube back slightly to make a tighter fit?
|
11th Apr 2010 3:42 pm |
|
|
ostland
Member Since: 16 Jan 2009
Location: Capital!
Posts: 89
|
Thanks I think I will look into doing the zip tie. I think it is rather loose all way, so I am afraid I don't think cutting it will work well in this case.
|
13th Apr 2010 4:09 pm |
|
|