Iain78
Member Since: 11 Nov 2015
Location: Durham
Posts: 63
  
|
| Two new fault codes for EPB |
|
I had a phone call from SWMBO saying there was a screaming sound from the car when she took the hand brake off, along with beeping and a flashing yellow triangle. I have used the IIDtool to try and unjam the epb, but that keeps saying failure. I did release the brake eventually, so the car is now home.
I have two fault codes from the epb;
U3000-4b (68) control module - system internal failure - over temperature
C1A46-64 (68) actuator plausibility check, mismatch between motor drive current and resultant force - algorithm based failure - signal plausibility failure
I have searched for these fault codes and have not found anything. I'm now thinking of servicing the epb module to see if that works. Any other ideas?
Last edited by Iain78 on 6th Feb 2016 3:15 pm. Edited 1 time in total
|
 6th Feb 2016 1:53 pm |
|
|
geoffsnook
Member Since: 13 Jun 2014
Location: south wales
Posts: 3170
|
Mine did this its probably because your hand brake has jammed and needs to be released i had those codes as they cables were not latched together  Discovery 3 se gone
Range rover sport supercharged here:)
|
| 6th Feb 2016 2:41 pm |
|
|
Iain78
Member Since: 11 Nov 2015
Location: Durham
Posts: 63
|
Great, just have to wait for the rain to stop so I can get under the car. Can the IIDtool be used to rewind the brass rod once I've unjammed it?
|
| 6th Feb 2016 3:15 pm |
|
|
geoffsnook
Member Since: 13 Jun 2014
Location: south wales
Posts: 3170
|
yes i think if you read the instructions you send it back to service and after back to normal Discovery 3 se gone
Range rover sport supercharged here:)
|
| 6th Feb 2016 3:17 pm |
|
|
Iain78
Member Since: 11 Nov 2015
Location: Durham
Posts: 63
|
Thanks Geoff
|
| 6th Feb 2016 3:30 pm |
|
|
