Member Since: 26 Feb 2008
Location: Knysna
Posts: 212
Heine still awaiting your trace for the plastic cut out please, or perhaps measurements from the 4 sides.
Putting prestik the 2 center sensors does cut out the continuous alarm, but will have to resort to the rotating trick.
5th Mar 2008 3:43 pm
heine
Member Since: 07 Feb 2007
Location: Midrand
Posts: 4054
Click image to enlarge
5th Mar 2008 7:26 pm
Rencolyn
Member Since: 26 Feb 2008
Location: Knysna
Posts: 212
Thanks Heine, you are a star! Buy you a six pack sometime or somethng similar.Ren Colyn
TDV6 HSE
5th Mar 2008 7:51 pm
heine
Member Since: 07 Feb 2007
Location: Midrand
Posts: 4054
No sweat swambo did all the work
6th Mar 2008 8:30 am
Rencolyn
Member Since: 26 Feb 2008
Location: Knysna
Posts: 212
I adjusted my PDC today but the existing slots were at the bottom of the hole, not as the previous pics show at the top. I drilled new slots to move the PDC 45 degrees & it works fine. I now get full alarm at 150mm, a bit close but ok. See my gallery.
One point of caution... when refitting the bumper, ensure that all 4 PDC units fit into the metalwork holes before securing the bumper. My outer one was not & it broke the plug assembly. Amazing what epoxy glue can fix!
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
Buy you a six pack sometime or somethng similar.
