Member Since: 16 Nov 2011
Location: Auckland
Posts: 58
Reverse signal for GVIF install
I'm half way through a GVIF install and I've found all the information I need on this forum to complete the install.
However, most people are getting the reverse signal way back at the actual taillight.
I'm just wondering if there is a better place to pickup the signal closer to where the gvif will be installed. ie. the passenger seat.
I'm assuming the gear shift probably has a reverse signal wire for example.
Anyone know where a better place to pickup the signal might be?
If running to the back is the easiest way, I'm also thinking the trailer wiring must have a reverse signal and is probably easier to tap than the taillight pigtails.
Any suggestions?
Thanks in advance.
12th Jul 2013 8:07 am
Chippy
Member Since: 05 Jan 2012
Location: Surrey
Posts: 520
Be interested in this myself as I was thinking the same thing. Was going to go of the gearbox switch.
All the one I have installed I have used the rear light source, its easy to connect and the cable is easily routed to the front down the side of the car to the gvif unit, takes 5 mins to run it under and behind the trim.
Flack
12th Jul 2013 9:04 am
wiggs
Member Since: 03 Sep 2006
Location: Manchester
Posts: 14372
Take it from the fuse boxG4 Gone ...but not forgotten
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum