pipelini
Member Since: 17 Mar 2012
Location: Leeds
Posts: 9
  
|
Developed a rattle on my March 2012 Disco 4 and on further inspection the offside tailpipe was loose and hanging on a single rubber support. Can anyone tell me if there should be more than this single support and should there be a rigid connection between the tail pipe and the main exhaust? or is it designed to be loose and twist? Would a repair be covered under the manufacturers warranty (its not impact damage).
|
 16th Feb 2013 9:53 pm |
|
|
JasM
Member Since: 16 Feb 2013
Location: Lanarkshire
Posts: 5
|
Should be covered under warranty. 
|
| 16th Feb 2013 9:57 pm |
|
|
pipelini
Member Since: 17 Mar 2012
Location: Leeds
Posts: 9
|
Had it into stealers yesterday; apparently a known fault with the exhaust where the weld between the main pipe and tailpipe fails. Should of been fixed today, but wrong parts delivered/ordered. Hopefully collecting tomorrow, assuming the right parts turn up?
|
| 19th Feb 2013 9:23 pm |
|
|
PaulC
Member Since: 27 Nov 2009
Location: Vale of Glamorgan
Posts: 112
 
|
Funny that, mine failed near side tailpipe at a join about 18" in front of tailpipe silencer. Land rover assist had seen a few- said it required new system from centre box backwards. Went to dealer- they have essentially pushed the pieces back together and clamped it tight. Consequently rather cheap and nasty looking 17mm nuts protruding beneath the exhaust which looks really naff and if I were selling no doubt would knock value off. Dealer has said it's LR's approved repair! Currently trying to resolve with LR customer service - not impressed in a car that cost >£50k and only 18 months old.
|
| 14th Apr 2013 7:00 pm |
|
|
wiggs
Member Since: 03 Sep 2006
Location: Manchester
Posts: 14372
|
mine went a few weeks back .(OSR)
they did a temp repair at first ...then said LR would only authorise a weld and not a replacement exhaust 
welded up a week later... all good again
the newer exhaust does not have the crimp on it now aparently G4 Gone ...but not forgotten
|
| 14th Apr 2013 7:15 pm |
|
|
