Anyone else encountered this? - was getting an odd vibration/rattle at tick over, slightly audible in car but a loud rattle outside as if there was a stone behind a heat shield or similar.
Just taken a look and the rear (right) exhaust is the problem - it is still suspended from its rubber mount but the join between it and the central section - it seems as if the two simply slot together? - has loosened and the rear section is therefore rotating freely around the central section pipe and therefore getting out of allignment & vibrating against the bodywork!
Anyone know if/how the 2 pipe sections are meant to be sealed together - there is no sign of a clamp on the left exhaust, so I reckon they must use some form of heat seal at the factory? Suggestions to fix? - is it a warranty job or a quick visit to an exhaust specialist; just seems rather poor quality to fail at 1 yr old!
17th Mar 2011 10:39 pm
WelshDisco
Member Since: 24 Sep 2007
Location: Cynon Valley
Posts: 123
Warranty Job! for sure.2010/60 Discovery 4 XS Zermatt Silver - Privacy Glass, Timed Climate (with remote), Voice, 4x4 screen, Bong on lock/un-lock (Pete BellAutos)
Discovery TDV6 SE (06) Gone!
Military 90 (1986) gone but not fogotten!
TV Option (Thanks to Wiggs)
Parrot CK3100
18th Mar 2011 9:01 am
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 73079
Warranty so main stealer, unless you want to pay for it.
18th Mar 2011 9:04 am
boris
Member Since: 22 Aug 2006
Location: Glasgow
Posts: 9
Just had the exact same fault. Cracked at what looks like sleeve fit no clamp I think it probably been an interference fit at the factory. Local dealer wants to weld the unit back together. Told them I’m not happy with this solution as the car is still under warranty and any welding I believe would only result in putting more stress into the unit for it to fail again sometime in the future. They have agreed to contact L/R regarding replacement. Waiting on answer.
19th Sep 2011 11:07 am
Q86ARR
Member Since: 23 Feb 2010
Location: Jersey
Posts: 379
Had one in like this too. Replaced the exhuast.
Welding is not a recognised LR repair.
Might be worth pointing your dealer to
SSM45957 - 3.0 TDV6 Centre Exhaust Muffler Weld Concern
Not sure if this covers your concern though.
19th Sep 2011 8:18 pm
boris
Member Since: 22 Aug 2006
Location: Glasgow
Posts: 9
Dealer has now confirmed that they will replace the exhaust system under warranty. No gnashing of teeth etc just good customer service. Big change in this dealers response since the service manager left some time ago.................!!!! Get the car back tomorrow.
20th Sep 2011 8:50 pm
DRRP
Member Since: 03 Oct 2012
Location: Glasgow
Posts: 28
Hello,
Just noticed this fault on my 6 month old D4. Rattle from the drivers side rear section of exhaust and more of the tail pipe visible below the back of the car than usual. Had a look underneath the car and as previously reported rear section still attached by hangers and rubbers, but rear section of pipe no longer properly secured to the centre section.
I'll be off to the dealers in the morning - good to know i should expect a replacement and not a "bodged" repair.
(Thanks for previous posts - it is always good to know you are not alone)
Best regards,
Dean
6th Jan 2013 5:47 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20840
Had this on a customers D4 recently. Was in for a service and rattle from exhaust. Noise was coming from the centre silencer, so the car was run into the local dealer. Replaced the whole rear section of exhaust under warranty My D3 Build Thread
Member Since: 27 Jan 2008
Location: Oxon
Posts: 708
Me too
15th Jan 2013 8:31 am
ronp
Member Since: 29 Nov 2006
Location: North Yorkshire
Posts: 15263
Had this issue too.
When standing outside with vehicle on tickover, it sounded like a low rest cycle on swmbo's washing machine.
Dealer replaced rear NS exhaust ( under warranty) so now washing machine free. ...... always on the road less travelled 🚧
15th Jan 2013 9:17 am
Robbie
Member Since: 05 Feb 2006
Location: ¯\_(ツ)_/¯
Posts: 17932
Bit of a surprise this given that Disco exhausts seem to last forever (well, relatively). Hope they are not changing to inferior components.Land Rover - Turning Drivers into Mechanics Since 1948
Range Rover Sport (LS)
Model Year: 2010-2012
VIN: AA212145-CA771688
MARKETS:
All Diesel Markets
CONDITION SUMMARY:
Situation:
This bulletin is for information only.
This version has been issued for a change to the Summary.
NOTE: The one piece exhaust is production fit only. For service repairs where the weld has broken prior to the cut off VIN numbers please refer to TOPIx Workshop Manual, section 309-00 Exhaust System for repair guidance.
A new (weld less) one piece exhaust system has now been introduced from Production from the following VIN numbers – Discovery 4 – CA638508 Range Rover Sport – CA771688
If appropriate a local repair of the weld can be claimed under a ZZZ001 warranty claim.
Cause: Poor weld during manufacturing of the exhaust at the supplier.TLO has left the building.......
I no longer work for a Landrover Dealer
My little chilli sauce business http://www.thechillees.co.uk
if you would like to order anything just give me a shout
15th Jan 2013 10:34 am
MartinR
Member Since: 27 Jan 2008
Location: Oxon
Posts: 708
Thanks!
15th Jan 2013 10:43 am
MartinR
Member Since: 27 Jan 2008
Location: Oxon
Posts: 708
Currently sitting in dealers while they remove the flappy bit, then they'll replace the part not weld. I'd expected this to be a bit more of a battle!
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
