Russell
Member Since: 24 Aug 2007
Location: Kent
Posts: 10564
|
Just got a set for D4 and looking at inst it would appear you need a captive nut tool similar to a pop rivet gun, is this correct, if so is there any way round this? If not as anyone got one I could borrow please.  MY17 D5 1st Edition Namib Orange
MY15 D4 HSE Kaikoura Stone
MY12 D4 HSE Nara Bronze Sold and gone
MY11 D4 HSE Stornaway Grey Sold and gone
D3 S spec Silver Sold and gone
Tow bar, full length roof bars, side steps, tow bar storage unit, surround camers.
D4 camera club
|
 11th Dec 2011 3:46 pm |
|
|
Bill Wright
Member Since: 03 Nov 2007
Location: Glorious Devon
Posts: 3254
  
|
I did it without the captive nut on my D3. I think that I used a self tapping screw but it was a few years ago so a bit hazy. Offer it up with that in mind and see where it takes you. Put a dob of paint in the hole before you screw in to deter the rust watch beetle.
Bill Wright Never take life too seriously. Nobody gets out alive anyway.
D4 SDV6 SE Tech Kaikoura Stone MY15.
|
| 11th Dec 2011 4:55 pm |
|
|
