Advertise on DISCO3.CO.UK
Forum · Gallery · Wiki · Shop · Sponsors
DISCO3.CO.UK > Technical (D3)

Another EPB problem, but slightly different
Post Reply  Down to end
Page 1 of 1
Stuarts the man
 


Member Since: 22 Sep 2011
Location: Glasgow
Posts: 423

Scotland 2005 Discovery 3 TDV6 SE Manual Buckingham BlueDiscovery 3
Another EPB problem, but slightly different

Hi
bought car but found handbrake shoes were lying loose inside disc, replaced both sides but now now red light just flashes. i can hear the modulator working, no screaching ,sounds like it is operating and is trying to tighten up cables but they are too long. showing fault on dash display, pulling up the switch 4 times does not reset it pushing down puts on yellow light. worked fine once when shoes were done, then red light constantly flashes.
Any help greatly appreciated
  
Post #8447967th Oct 2011 11:10 pm
View user's profile Send private message View poster's gallery Reply with quote
Dave T
 


Member Since: 03 Jul 2009
Location: Glasgow
Posts: 6903

England 

was it from a dealer? if so take it straight back, otherwise a trip to disco_mikey at Strathearn may be in order! Other option would be to check Bodsy's brake bible, just to check that you have done everything right, it is linked from his signature block, just find a post by him.
 Joined the BMWX5 45e group
1994 Defender 90

2015 RRS Corris Grey/Black roof
2016 D4 Graphite Santorini Black
2012 D4 XS Orkney Grey
2005 D3 S Maya Gold

Convoy for Heroes 2011 
 
Post #8448148th Oct 2011 4:58 am
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
Disco_Mikey
 


Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20757

Scotland 2005 Discovery 3 TDV6 HSE Auto Cairns BlueDiscovery 3

Was the handbrake module working previously, before replacing the shoes? Even if it was screeching

Could be something simple like a faulty switch. Have you had the fault codes read yet?
 My D3 Build Thread

TDV8 Retrofit Build Thread 
 
Post #8448188th Oct 2011 6:36 am
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
Stuarts the man
 


Member Since: 22 Sep 2011
Location: Glasgow
Posts: 423

Scotland 2005 Discovery 3 TDV6 SE Manual Buckingham BlueDiscovery 3

got fault codes read on launch x431, only showed up motor power supply.this then cleared.red light was steady when we collected car. we replaced back brakes , but could not get it to work. then ran it at 10mph and pulled on handbrake and it stopped car. after this it started flashing and cant get it to operate now. when you pull lever up you can here the module working but it does not seem to be tightening the cables, could this be stuck in mounting mode?
  
Post #8448598th Oct 2011 11:06 am
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO3.CO.UK is independent and not affiliated to Land Rover.
Switch to Mobile Site