DEREK MAUNDERS
Member Since: 24 Dec 2009
Location: OLNEY
Posts: 42
  
|
Good morning everybody
I have bought a 59 reg Discovery 4 which I use for towing full time. because it is a 59 reg I have to have a digital tachograph fitted, I have been told that the discovery 4 already has the necessary wiring in place and would only need to buy the digital tachograph head.
Can anybody advise on this? Would appreciate any info
Kind regards
Derek
DPJ Disco
|
 14th Aug 2011 7:54 am |
|
|
DiscoDunc
Member Since: 08 May 2006
Location: Bristol
Posts: 16390
 
|
have you tried doing a search ?
quite a few have asked the same question in the past 
type +tachograph, into the search screen Duncan
-----------------------------------------------------
If I'd known I was going to be so thirsty this morning I'd have drunk more beer last night.
FFRR Autobiography 4.4 SDV8 MY17
D4 HSE MY13 SOLD
FFRR 3.6 Vogue TDV8 SOLD
D4 HSE MY10 SOLD
D4 SE TECH MY15 SOLD
D4 XS MY12 SOLD
D4 HSE MY10 SOLD
D3 HSE MY06 - Re-Cycled Worldwide
|
| 14th Aug 2011 8:09 am |
|
|
Walkzinho
Member Since: 01 Oct 2011
Location: Chester
Posts: 140
 
|
I have searched every thread on the forum regarding the fitment of the unit in the cab but cannot find any definitive answers. The only method I've come across is attaching it to the roof behind the light panel, that sounds like it requires a certain amount of butchery?
|
| 1st Oct 2011 5:59 pm |
|
|
Randylover
Member Since: 31 Jan 2011
Location: Staffordshire
Posts: 1172
|
Mines an 05 d3 so analogue for me î„î„î„î„, had mine fitted just under glove box still accessible but out of the way to, when I was stoPped by VOSA they had no probs with location
Cheers
Andy 05 TDV6,"S" in all colourcoded Zermatt silver,7 seats winter pack HK 6cd stereo,Dual climate,Xenons,
Mods:
Re-Con Engine,De-Tango,Reverse camera,Fog/DRl lights,Aux Battery, perm Aux socket in boot,LED Volt meters in roof panel,Built in tom tom, Strobes fitted in grille, Aux switches for trailer lights fitted in roof panel,Roof Rails,Grille conversion
|
| 1st Oct 2011 11:42 pm |
|
|
character
Member Since: 31 Dec 2007
Location: wiltshire
Posts: 5781
|
DEREK MAUNDERS wrote: I have been told that the discovery 4 already has the necessary wiring in place and would only need to buy the digital tachograph head.
hi the d4 is "compatable" with a digital tacho as the wiring loom has been adapted however its not just a plug and play affair. The tacho unit itself should come with the necessary cables if not my understanding is that these can be bought from LR (the cable that it).
Obviously the units has to be calibrated by a VOSA approved workshop although most people get such a place to source and fit the whole thing at the same time, that said the unit should be "within easy reach" for the driver but of course the D4 is a lot harder to place so my view might be to have it installed in the upper glovebox and temp take off the flap as I've seen in both D3/D4's but of course its your decision after taking advice from your local VOSA approved installer 
|
| 1st Oct 2011 11:57 pm |
|
|
