chris d3
Member Since: 21 Jun 2009
Location: sunderland
Posts: 423
|
I noticed the other day when i changed my front brake pads there was a bit of play on the front hub.Ive borrowed a torque wrench and was going to try and nip it up.Could anyone tell me is there a locking tab on the hub nut
Thanks Chris
|
9th Oct 2011 10:55 pm |
|
|
Bodsy
Site Sponsor
Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361
|
the hub nut has an in built 'locking tab' all the way around. Depending on how hard its been hit in, you should be able to tap it out with a chisel/screwdriver or just tighten a fraction and then re-tap it down. Bodsys Brake Bible
D4/D3 Remote FBH heat kits
BAS Remaps/ EGR Blank
Transmission Flush
Software updates/enabling
Clock/ SNOTM /3Flash / 4x4Info /BT Update /Service Reset/Error Codes / Gearbox Reset
See It Here
|
9th Oct 2011 10:57 pm |
|
|
DN
D3 Decade
Member Since: 24 Jun 2006
Location: W.London.
Posts: 2326
|
Chris, the 'hub' nut only secures the driveshaft in position, I think if you have play here, then the wheel bearing must be a bit worn, easily replaced though fortunately ( unlike the rear ones).
|
9th Oct 2011 11:16 pm |
|
|
chris d3
Member Since: 21 Jun 2009
Location: sunderland
Posts: 423
|
Cheers lads
|
9th Oct 2011 11:38 pm |
|
|