Hi,
Has anybody ever seen the message 'Suspension normal height only'? I ask because its a touch strange, i know my compressor is working because the car still self levels when on a hill but if i try to lower or raise the car i get the message above? I wondered if anybody could shed some light on it?
Thanks in advance for any help offered.
26th May 2011 10:24 am
chrisbowler
Member Since: 30 Jan 2009
Location: UK WALES
Posts: 176
Check wiring to driver side front ride height sensor and front valve block - had same on my 05 D3 and found 2 broken wires - MADE OVERLAY LOOM AND PROBLEM WENT AWAY. Remove inner wheel arch liner in passenger side to see connectors.
Chris BowlerChris Bowler
D3 2005 EXPEDITION
D2 Challenge Vehicle
300 TDi Spare car
107" TD5 Comp Safari Motor
28th May 2011 6:01 pm
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 73038
Thanks, I'll take a look in the morning at the wiring, if the compressor was fubared would it still self level when parked on an incline?
28th May 2011 6:47 pm
John C
Member Since: 28 Aug 2007
Location: East Yorkshire
Posts: 3292
Check the relay for the comressor isn't sticking on.2020 SDV6 D5 HSE, Carpathian Grey +
2022 Tesla Model Y LR... almost Carpathian Grey
Previously : 2005 TDV6 SE Auto, Cairns Blue (288K) - ours for 16 years
Scuse my ignorance..... but how would i go about doing that??
28th May 2011 6:52 pm
curlycol
Member Since: 12 Apr 2011
Location: Scotland
Posts: 5
Similar issues on my D3, 6x dealer repairs later they are now recommending a new wiring loom, not impressed, wiring not covered by warranty, sure that the wiring should last a little longer than 5-6 yearsDark Disco 3 - 20" but chunky tyres
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum