Member Since: 19 Jan 2019
Location: Lancing
Posts: 11
FBH pump issue?
Hi. Am after a bit of advise diagnosing the problem with the FBH. After clearing the faults, (No start, code 02h. Heating interlock, code 07h. Metering pump interlock 88h) My heater starts up, has a bit of smoke and then shuts down.
Thinking there might be a pump fault, I pulled off the pipe from the FBH and ran a prime and then a pump test via the diags. I can hear the pump clicking away.. Question is, how much fuel should come out of the pipe? Mine seems to produce enough small drips that might fill a teaspoon in 60 seconds.
Thank you in advance for any help.
Mark
19th Jan 2019 2:58 pm
salmoner
Member Since: 09 May 2014
Location: Blackpool
Posts: 156
How much fuel is in your tank
19th Jan 2019 3:02 pm
Krumble
Member Since: 19 Jan 2019
Location: Lancing
Posts: 11
Hi. Currently 3/4 tank. on the gauge.
Rgds
19th Jan 2019 3:05 pm
salmoner
Member Since: 09 May 2014
Location: Blackpool
Posts: 156
that's ok I had an issue last year and found out the tanks needs to be at least a 1/4 full for it to work have you tested the fbh with your iid ??
19th Jan 2019 3:13 pm
Krumble
Member Since: 19 Jan 2019
Location: Lancing
Posts: 11
Hi, I have been using the Webasto WTT diagnostic software via the laptop to run the tests.
19th Jan 2019 3:18 pm
salmoner
Member Since: 09 May 2014
Location: Blackpool
Posts: 156
Don't know about the Webasto WTT diagnostic software but use my iid to run it , think I re primed it at the same time seems ok now . I'm sure some one with a bit more knowledge will be along soon
19th Jan 2019 3:23 pm
Martin Site Admin and Owner
Member Since: 06 Nov 2004
Location: Hook Norton
Posts: 18508
Driven by WTT software at 7Hz frequency the pump should deliver 40ml in 180 seconds.
Source: ThermoTop V workshop manual
06 D3 SE / 15 LR D90 XS SW / 88 LR 90 Td5 / 68 BMW 2000 ti
Any issues with the site let me know!
19th Jan 2019 3:36 pm
Krumble
Member Since: 19 Jan 2019
Location: Lancing
Posts: 11
Brilliant. I will try that. BTW do you know if it should squirt from the pipe to the FBH or slowly drip?
Thanks
19th Jan 2019 3:39 pm
Martin Site Admin and Owner
Member Since: 06 Nov 2004
Location: Hook Norton
Posts: 18508
Given it 8 teaspoons in 3 minutes it is a drip feed 06 D3 SE / 15 LR D90 XS SW / 88 LR 90 Td5 / 68 BMW 2000 ti
Any issues with the site let me know!
19th Jan 2019 3:40 pm
Krumble
Member Since: 19 Jan 2019
Location: Lancing
Posts: 11
Hi Martin.
Have just nipped out to run the pump test 7Hz 180 secs. Produced exactly 2 x teaspoons worth so deducing FBH is starving of fuel. Time for a new pump I guess, unless you know of anything else to check first.
Regards
Mark
19th Jan 2019 4:12 pm
Martin Site Admin and Owner
Member Since: 06 Nov 2004
Location: Hook Norton
Posts: 18508
Remove the feed pipe from the tank to the pump and blow it out (from pump end into tank).
Remove the pipe from the pump outlet and the FBH and blow down from the FBH end.
This will clear any blockages. Often the tank to pump one blocks and restricts the supply.06 D3 SE / 15 LR D90 XS SW / 88 LR 90 Td5 / 68 BMW 2000 ti
Any issues with the site let me know!
19th Jan 2019 4:22 pm
Krumble
Member Since: 19 Jan 2019
Location: Lancing
Posts: 11
Cheers,
I will give that a go before ordering a pump.
When you say blow down the pipe to the tank, I was thinking about using my workshop air line.
Would that be ok?
I am not familiar with the fuel pipe plumbing of the discovery and would be concerned about introducing air to the engine fuel supply / filter, or bug**ring something else up.
19th Jan 2019 4:37 pm
Martin Site Admin and Owner
Member Since: 06 Nov 2004
Location: Hook Norton
Posts: 18508
Yes use the airline. The FBH supply is independent of the engine fuel supply 06 D3 SE / 15 LR D90 XS SW / 88 LR 90 Td5 / 68 BMW 2000 ti
Any issues with the site let me know!
19th Jan 2019 4:38 pm
Krumble
Member Since: 19 Jan 2019
Location: Lancing
Posts: 11
Excellent. Thank you very much for your help.
Mark
19th Jan 2019 4:42 pm
jonathanrichards
Member Since: 11 Jan 2018
Location: Hull
Posts: 152
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum