Taking the front bumper off - so far so good...but there are 4 torx screws underneath the bumper and they refuse to undo. They are just not turning...are these the ones that are meant to be undone...?
Think I've now stripped a couple as well whilst trying...now what...?The next American ex-pat that calls it a "truck" is going to find out what 2.7 tons feels like on their foot...
Club "yes, I too have had the EGR's replaced..."
Club "yes, I too have had the compressor replaced..."
Club "yes, I too once had the car at the dealer for a couple of weeksnearly 4 weeksover 4 weeks...5 weeks"
Club "yes, I too have had EPB failure..."
Club "yes, I too get mysterious bings and bongs..."
Last edited by JF Lux on 11th Jul 2010 8:34 pm. Edited 1 time in total
yes they need to come outHome of RLD Hidden winch mounts Spare wheel Locks Trailer Body Fabrication [email protected] D3/4 sump plates MY 14 sump plates and the Discovery Sport wheel protectors Discovery 5 wheel locks
more Helsport tents and other things for camping Law of Mechanical Repair:
"After your hands are coated with grease, your nose will begin to itch and you'll have to pee!"
11th Jul 2010 11:55 am
MacLeod 313
Member Since: 18 Apr 2008
Location: away
Posts: 10723
If you are referring to the 4 screws that fit along the edge, very near to the Mantec/RLD, then YES, they need to come out John
3 won't move...1 of those is now stripped...and 1 has snapped and will need to be drilled out... The next American ex-pat that calls it a "truck" is going to find out what 2.7 tons feels like on their foot...
Club "yes, I too have had the EGR's replaced..."
Club "yes, I too have had the compressor replaced..."
Club "yes, I too once had the car at the dealer for a couple of weeksnearly 4 weeksover 4 weeks...5 weeks"
Club "yes, I too have had EPB failure..."
Club "yes, I too get mysterious bings and bongs..."
11th Jul 2010 12:12 pm
Bodsy Site Sponsor
Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361
I snapped one of mine yesterday, another head went tits up, but had enouigh space to get a wrench on it.
the remaining two came out by using the loosen it, tighten a bit, loosen it more method.
I only used two to hold it back on now and put plenty of copper grease on to try to aime removal next time.
Invest in a drill bit and screw remover.....
I think it's because the mantec plate had been crudded up a few times and retained the mud/water for longer than it would have.Bodsys Brake Bible
And all four screws sheared off... hopefully the RLD plate will go some way to keep it all in place...
Suppose I'll have to Araldite it when I remount... The next American ex-pat that calls it a "truck" is going to find out what 2.7 tons feels like on their foot...
Club "yes, I too have had the EGR's replaced..."
Club "yes, I too have had the compressor replaced..."
Club "yes, I too once had the car at the dealer for a couple of weeksnearly 4 weeksover 4 weeks...5 weeks"
Club "yes, I too have had EPB failure..."
Club "yes, I too get mysterious bings and bongs..."
well it was off...it has gone back on...intercooler looked fine. But I cleared out about 2 years worth of mud from inside the bumper...
flushed it out
and this was hiding in the bumper and is just from one side - weighed a few kilos...
The next American ex-pat that calls it a "truck" is going to find out what 2.7 tons feels like on their foot...
Club "yes, I too have had the EGR's replaced..."
Club "yes, I too have had the compressor replaced..."
Club "yes, I too once had the car at the dealer for a couple of weeksnearly 4 weeksover 4 weeks...5 weeks"
Club "yes, I too have had EPB failure..."
Club "yes, I too get mysterious bings and bongs..."
drill out the old bolts they are not very hard tap the end with a centre punch before you drill them then re tap other wise it may flap about use a smaller drill toHome of RLD Hidden winch mounts Spare wheel Locks Trailer Body Fabrication [email protected] D3/4 sump plates MY 14 sump plates and the Discovery Sport wheel protectors Discovery 5 wheel locks
more Helsport tents and other things for camping Law of Mechanical Repair:
"After your hands are coated with grease, your nose will begin to itch and you'll have to pee!"
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum