My little chilli sauce business http://www.thechillees.co.uk
if you would like to order anything just give me a shout
7th Jul 2010 10:05 pm
DSL Keeper of the wheelie bin
Member Since: 11 May 2006
Location: Off again! :-)
Posts: 72955
Now that's some thought for the day Nick!
7th Jul 2010 10:25 pm
stump cutter
Member Since: 30 Jun 2010
Location: wales / hereford border
Posts: 5
yep i think i have all the parts, just need a bit of confidence to start the job. thx
7th Jul 2010 11:38 pm
tanters
Member Since: 24 Oct 2007
Location: Oireland
Posts: 4286
You ll probably break one of the clips off the vent when you're removing it, that's normal A happy childhood ... is the worst possible preparation for life.
7th Jul 2010 11:47 pm
Chicken Duck
Member Since: 11 Nov 2009
Location: Italy
Posts: 1387
First take off the side air vent. To do this try inserting a plastic spatula underneath(the two clips are underneath) whilst pulling out and up at same time. I did break one of the retaining pegs. Next mask the wing round the vent were the RAI will sit. this is to prevent scratching from metal part of RAI and also to mark holes for riv nuts. Offer up the RAI get another pair of hands and sit it on Disco and slot the metal gaskit into the side vent. When its sitting pretty push pen through both holes to mark were your going to drill the wing. The drill size is 9mm. To get A pillar trim off i started at the bottom. Open bonnet and get long flat screw driver. Wrap cloth round screw driver to stop it scratching A pillar and work it upwards under trim whils pulling up and out at same time. I did mine on a hot day and none of the clips broke except the top retaining peg. The top peg needs to be cut anyway because thats were you drill the 3rd hole for the riv nut.Again this is 9mm. The trim needs to be drilled as wellThe instructions sate 14mm but i did mine at 11 It's a good idea to order some spare clips before you start (part noEYC500090) These have small thin rubber washers behind to stop A pillar leaking into car. Good luck and just keep alligning RAI before you drill to make sure. Also don't even attempt it with out Rivnut tool. Cheap ones can be had on the bay for a tenner. EDIT i siliconed all round the gaskit and wing to make it as water tight as posible EDIT 2 = sh t spelling and drill size's
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
Its the G4 type snorkel for the D3.
t spelling and drill size's
