ozd4
Member Since: 11 Nov 2009
Location: Queensland
Posts: 92
|
Hi,
When raising suspension rear goes straight up but front very slow.
access to normal 45 sec
normal to off road 1min15sec
Have back to deal said recalibration, but just found still the same.
Any ideas.
Cheers Ken
|
23rd Jan 2010 11:30 pm |
|
|
caverD3
Member Since: 02 Jul 2006
Location: Oberon, NSW
Posts: 6922
|
Leak in the air lines?
Or is yours in this VIN range?
Ride Height Sensor - Service Action
Just had this issued friday
Only a small chassis number run
Disco3
LA461580 - LA513324
RRS
LS144333 - LS215577
If you fall in this bracket then your dealer (Like the fuel pumps and vac pipes) should contact you direct or receive a letter from LR advising to contact dealer
http://www.disco3.co.uk/gallery/albums/use...Action.pdf “There are only three sports: bullfighting, motor racing, and mountaineering; all the rest are merely gamesâ€
Ernest Hemmingway
D4 3.0 Active Diff, Adaptive Lights, High Beam Assist, Surround Cameras, Privacy Glass.
D3 2.7:Adaptive Headlights,Electronic Rear Diff,ARB Bar,Blaupunkt Speakers,JVC Powered Subwoofer,Removable Snorkel,Mitch Hitch,Pioneer After Market Head Unit,Steering Wheel Control Adaptor,Remote Adjustable Supension Rod System, Taxside Dual Battery System.
|
24th Jan 2010 1:43 am |
|
|
ozd4
Member Since: 11 Nov 2009
Location: Queensland
Posts: 92
|
Hi Caver, its a D4 so looks like a leak.
Thanks Ken
|
24th Jan 2010 1:55 am |
|
|
GraemeS
Member Since: 17 Mar 2008
Location: NSW
Posts: 706
|
It might be worth checking that the sensor wiring loom to the RF hasn't chaffed on the heat shield where the loom goes over the chassis just behind the RF sensor. I bent up the bottom lip of the shield as the wiring was rubbing.
|
24th Jan 2010 3:50 am |
|
|
ozd4
Member Since: 11 Nov 2009
Location: Queensland
Posts: 92
|
GraemeS wrote:It might be worth checking that the sensor wiring loom to the RF hasn't chaffed on the heat shield where the loom goes over the chassis just behind the RF sensor. I bent up the bottom lip of the shield as the wiring was rubbing.
Thanks, saw your earlier post, and did check mine ,it was OK.
|
24th Jan 2010 8:15 am |
|
|