Member Since: 07 Apr 2012
Location: Germany
Posts: 36
Car alarm....bonnet sensor?
Hi lads,
I had a few embarrasing incidents recently when the car alarm just came on even though nobody had touched the car. I suspect the bonnet sensor because when I checked on the dashboard it said "bonnet open" even though it was definitely closed. Is that a common fault? I located it on the left lock(standing in front of the car) and I flooded it in WD 40. Will that do the trick or will I have to order a new sensor? Or is there another fix?
Greetings from Germany and stay healthy everybody,
Ralph
27th Mar 2020 4:02 pm
rrhool
Member Since: 28 Aug 2014
Location: Norfolk
Posts: 4540
Yes, very common.
You can temporarily bridge the two wires with a paper clip, or a wire with spades on, to stop the alarm.Richard
D3 SE 2007. Triumph 2.5Pi 1973. Ferguson TEA20 1948.
Discovery 2 4.0 ES 2001- Gone
Discovery 1 300Tdi ES '95 - Gone
Range Rover Classic '79 - Gone
27th Mar 2020 4:13 pm
The Wild Rover
Member Since: 07 Apr 2012
Location: Germany
Posts: 36
Cheers Richard!
I just found this video which might be handy if anybody has a similar problem:
I just do the same as those guys and give it a good clean. If that doesn't do the trick, does anybody know if you can buy the actual switch assembly without the lock separately? So far I have only found the complete lock assembly, but the lock is fine of course and swapping out the micro switch looks dead easy.
take care,
Ralph
27th Mar 2020 5:12 pm
rrhool
Member Since: 28 Aug 2014
Location: Norfolk
Posts: 4540
worth a go!Richard
D3 SE 2007. Triumph 2.5Pi 1973. Ferguson TEA20 1948.
Discovery 2 4.0 ES 2001- Gone
Discovery 1 300Tdi ES '95 - Gone
Range Rover Classic '79 - Gone
27th Mar 2020 7:17 pm
Yargo
Member Since: 25 Dec 2020
Location: Europe
Posts: 326
I had same problem. Fixed in 5 min. Remove bonnet latch, remove switch from latch, there is a tiny metal clip - bend it up slightly and assemble.
29th Dec 2020 12:16 pm
Ranger Rover
Member Since: 16 Oct 2023
Location: Houston
Posts: 4
Bonnet Open Message and Alarm
I have had the same problem, but only early in the morning, and only when I temperature cools.
The switch has now been replaced twice, and I have spent hours adjusting the hood height and the switch/ lock height.
All to no avail.
Thanks in advance for any help,
25th Nov 2023 3:00 pm
kajtzu
Member Since: 10 Aug 2017
Location: Helsinki
Posts: 6769
Oops, wrong thread.
26th Nov 2023 8:00 pm
florent
Member Since: 04 Apr 2009
Location: Bordeaux
Posts: 103
Thanks for the tip, removing the sensor, cleaning it and slightly bending upwards did the trick.
My alarm went ringing & I had the message hood open sometimes (when it was not).Serial Land Lover - (3 Defenders, 8 Range Rovers, 2 Freelanders, 4 D3s... to be continued)
9th Dec 2024 9:59 am
reb78
Member Since: 21 Apr 2018
Location: Herts
Posts: 228
rrhool wrote:
Yes, very common.
You can temporarily bridge the two wires with a paper clip, or a wire with spades on, to stop the alarm.
Haha - that was temporary for me about 7 years ago.... its still temporary.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum