Advertise on DISCO3.CO.UK
Forum · Gallery · Wiki · Shop · Sponsors
DISCO3.CO.UK > Technical (D3)

Unable to select access mode and low range using switches
Post Reply  Down to end
Page 1 of 1
thegrimreaper1979
 


Member Since: 15 Mar 2024
Location: Sussex
Posts: 15

United Kingdom 2008 Discovery 3 TDV6 GS Auto Barolo BlackDiscovery 3
Unable to select access mode and low range using switches

Good morning all,

For a while now i have been unable to select low range and access mode using the switches, I have tried various things and still no closer so hoping for a bit of advice, i will bullet point below for ease of reading

No faults shown in IID tool and can control the suspension by dropping the valves
Can select access height and when i exceed the speed set it drops back into normal mode but cannot lower with the switch
The IID tool shows doors closed when closed and open when open
Tried cleaning switch contacts, no joy so brought replacement panel off ebay - still no joy

So what's the next steps? my thoughts are below

1. Could both switch panels be faulty with the same fault - possible but unlikely
2. Wiring fault
3. Anything else i might have missed that you wonderful people can suggest?

Thanks for reading if you made it this far Laughing
  
Post #237590926th Aug 2024 9:04 am
View user's profile Send private message View poster's gallery Reply with quote
Pete K
 


Member Since: 15 Jan 2016
Location: GL
Posts: 10672

England 2005 Discovery 3 TDV6 HSE Auto Rimini RedDiscovery 3

Do any of the orange lights on the switch panel change/respond when you press the buttons?

I would use the IID tool to look at suspension live values > switch inputs
and see if they change when you press the buttons up and down.

And/or find the ecu to the right of the throttle pedal, and see if the switch wires change when pressed.
  
Post #237592126th Aug 2024 11:01 am
View user's profile Send private message View poster's gallery Reply with quote
thegrimreaper1979
 


Member Since: 15 Mar 2024
Location: Sussex
Posts: 15

United Kingdom 2008 Discovery 3 TDV6 GS Auto Barolo BlackDiscovery 3

Thanks Pete, I have just checked the IID for when the switch changes it only registers the up switch press nothing else, so now I've just got the circuit board out and am checking for continuity before going to delve in to the ECU, currently I am only getting continuity between the switch and what I assume is the link to the mud/snow/gravel switch and that gives continuity on both the up and down switch, as yet no continuity to the black and white wire , this may be nothing as I also get no continuity between the up switch and black and purple wire ( sorry this is mostly just me thinking out loud)

Also edited to add - no the LED doesn't change, it just stays lit on off road light which is what mode it is currently
  
Post #237592426th Aug 2024 12:26 pm
View user's profile Send private message View poster's gallery Reply with quote
thegrimreaper1979
 


Member Since: 15 Mar 2024
Location: Sussex
Posts: 15

United Kingdom 2008 Discovery 3 TDV6 GS Auto Barolo BlackDiscovery 3

Pete K wrote:

And/or find the ecu to the right of the throttle pedal, and see if the switch wires change when pressed.


At the risk of a potentially really stupid question shouldn't the ECU be fairly obvious? I can't see it 🤣

Click image to enlarge
  
Post #237593226th Aug 2024 4:47 pm
View user's profile Send private message View poster's gallery Reply with quote
Pete K
 


Member Since: 15 Jan 2016
Location: GL
Posts: 10672

England 2005 Discovery 3 TDV6 HSE Auto Rimini RedDiscovery 3

It’s up a bit higher

You should be able to see the connectors at the bottom. (From vague memory )

Is it worth fitting the other switch pack and see if the same switch isn’t working
  
Post #237593826th Aug 2024 5:48 pm
View user's profile Send private message View poster's gallery Reply with quote
thegrimreaper1979
 


Member Since: 15 Mar 2024
Location: Sussex
Posts: 15

United Kingdom 2008 Discovery 3 TDV6 GS Auto Barolo BlackDiscovery 3

Thanks,

I have tried both switch packs now and same on both,

I'll have another look tomorrow, I'll have to try and limber up and put on my best contortion effort then, which as a larger chap will be good fun lol
  
Post #237593926th Aug 2024 6:08 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO3.CO.UK is independent and not affiliated to Land Rover.
Switch to Mobile Site