tommymcg
Member Since: 06 Feb 2023
Location: Dundee
Posts: 41
  
|
| D3 2008 2.7 diesel EPB cable routing |
|
Hi Folks
The previous EPB has failed, just purchased a used item and trying to install.
Used the trusty string method but the cable route is not making any sense. I think the previous owner when he replaced the EPB did not install it correctly, hence the reason it has failed. The first 2 clips secured by 8mm fasteners are easy enough on both sides. What is the route for the passengers side? Over or under the anti-roll bar? Or is down the inside of the chassis leg then out at the corner of the wishbone? Thought that would be too close to the exhaust?
Did manage to print off a JLR drawing but it does not give sufficient detail. Any advice would be most welcome.
|
 13th Sep 2024 3:23 pm |
|
|
M3DPO
Member Since: 22 Sep 2010
Location: Notts.
Posts: 8223
  
|
There should be a support pigtail ring for the cable to go through to stop it rubbing on the tyre if that is any help. It can when others can't,
It will when others won't,
It goes where others don't.
|
| 13th Sep 2024 4:37 pm |
|
|
tommymcg
Member Since: 06 Feb 2023
Location: Dundee
Posts: 41
|
Thanks
|
| 13th Sep 2024 10:38 pm |
|
|
