Member Since: 09 Mar 2007
Location: hants
Posts: 2144
Snapped hub stud
I have a wheel nut which has snapped off the the hub stud
Firstly is it safe enough to run on 4 wheel nuts only ?
And I assume the only fix is a new hub ?
Your help much appreciated chaps
Illegitimi Non Carborundum
26th Aug 2023 8:46 pm
kajtzu
Member Since: 11 Aug 2017
Location: Helsinki
Posts: 6668
I would not drive around with only four wheel nuts.
26th Aug 2023 9:31 pm
CDS Site Sponsor
Member Since: 12 Oct 2009
Location: All over the UK!
Posts: 3331
If you can find a stud then it can be replaced, IIRC they are not available as separate part though
Discovery 3/4 & RRS keys cut and programmed at your home or work
Apple CarPlay/ Android Auto retro fit - see it here
BAS Remaps/ EGR Blanking
Software updates/ enabling
Mobile Servicing & Repairs
26th Aug 2023 10:14 pm
ronald.soak
Member Since: 29 Apr 2008
Location: London
Posts: 521
The old stud can be punched out, towards the differential.
I don't think replacement studs are available although they are for some other cars.
A recovered stud can be fitted and I have 4, 1 of which I could send you.
BUT. I previously sent a stud to another member and although I had to use a club hammer to extract it he found that it rotated when fitted in his hub. This might be due to a design change, my hub is an original from 2005, or the hole in his hub may have been enlarged when the wheelnut was over tightened.
Can you see how difficult it is to hammer out your broken stud and try to identify if your hub is an original or a replacement?.
If you let me know and PM me your address I'll post you a stud.
Personally I think 4 wheelnuts should be sufficient short-term but you might have balance problems.
John
26th Aug 2023 10:44 pm
sacimiddx
Member Since: 09 Mar 2007
Location: hants
Posts: 2144
thanks ronald.soak
i think I may go for full hub replacement
part not that expensiveIllegitimi Non Carborundum
28th Aug 2023 9:45 am
ronald.soak
Member Since: 29 Apr 2008
Location: London
Posts: 521
Probably best. The state of the wheelnut looks pretty grim. If any of the other nuts are corroded onto their studs you could have further failures.
Advice from the forum is not to buy the cheapest hubs because of their short lifespan.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum