Longy
Member Since: 03 Mar 2023
Location: Nottingham
Posts: 27
![](templates/vbnew/images/spacer.gif)
![2012 Discovery 4 3.0 SDV6 HSE Auto Zermatt Silver 2012 Discovery 4 3.0 SDV6 HSE Auto Zermatt Silver](../images/veh/zermatt_silver.gif)
|
I've got the standard heater matrix block, heat only coming from the drivers (RHD) centre vent, all others only slightly get warmish!
I've tried the flush and back flush but without any result. I've come to the conclusion it needs a new heater core.
I've seen the heater core swapped out on a D3 and you can just swap out the heater core itself, no new pipes so a relatively easyish job. My question is can the same be done on a D4, can you just pull the heater matrix out and leave the pipes on situ and reuse? My worry is it'll be a full dash out job in order to replace the pipes as well.
Any advice is appreciated.[/i]
|
14th Jun 2023 8:26 am |
|
|
ianm27
Member Since: 02 Jun 2016
Location: Hertfordshire
Posts: 2154
![](templates/vbnew/images/spacer.gif)
![2012 Discovery 4 3.0 SDV6 GS Auto Orkney Grey 2012 Discovery 4 3.0 SDV6 GS Auto Orkney Grey](../images/veh/orkney_grey.gif)
|
I understand it is a full dash out to replace the matrix.
However I'm sure someone with more knowledge will be along to confirm or tell you I'm talking through my hat Uncle Ray's spare wheel protector
Limo Tint
Blackvue front & rear dashcam
Cruise control switch pack
Bodsy's remote for FBH
|
14th Jun 2023 11:29 am |
|
|