|
|
DN
D3 Decade
Member Since: 24 Jun 2006
Location: W.London.
Posts: 2319
  
|
I was quite disappointed with the centre support on a new GKN rear propshaft, the rubber is very thin and flimsy, and I can’t see it lasting long at all. This is a much more sturdy option if the centre bearing support failing is all that is wrong with an existing propshaft, but I wish it wasn’t so expensive  Building up a reinforcing layer of Sikaflex around the failing rubber support, is another ( much cheaper ) option. D3 owned from new, P017 brake recall, BAS FBHIC, new FBH, LR013487 oil pump, new water pump. RRS front lower suspension arms. New suspension compressor/ relay. New Denso alternator. CuNifer rear brake pipes. New GKN rear propshaft. New HPFP belt & tensioner. New A/C Condenser.NO WARRANTY for many many years.
|
 1st Apr 2023 3:41 pm |
|
|
monty1
Member Since: 08 Feb 2016
Location: middlesbrough
Posts: 316
|
this certainly seems more substantial, also no need to remove the prop and half the cost 
|
| 2nd Apr 2023 2:25 am |
|
|
