Miukuli
Member Since: 22 Dec 2022
Location: Europe
Posts: 1
|
Hello my 2005 discovery 3 with 2.7tdv6 and about 345tkm. It did start well on the morning, but when i was scraping ice off windows it started to run oddly and then it stalled. And wont start.
Fuel pressures are ok.
I have these fault codes:
P02a3 cylinder 3 balance - fiel trim at minimum limit
P029a cylinder 1 balance - fiel trim at maximum limit
P029e cylinder 2 balance - fiel trim at maximum limit
P02a6 cylinder 4 balance - fiel trim at maximum limit
P02aa cylinder 5 balance - fiel trim at maximum limit
P02ae cylinder 6 balance - fiel trim at maximum limit
P0578 speed control multi function input a circuit is stuck
P121a cyliber balance ?injector restricted
When i try to start it, i almost runs when i hold key on start but stalls immidetly when i release key.
So is it injector 3 dead?
|
 22nd Dec 2022 4:58 pm |
|
|
Globetrotter448
Member Since: 21 Mar 2017
Location: Londonderry NSW
Posts: 1822
  
|
I would try a system reset first, assuming battery is fully charged. Disconnect battery terminals and short the two leads, you may need a screwdriver to bridge the gap. if that does not work, then remove the battery and check the connections to ECU which is behind the battery.
|
| 29th Dec 2022 2:52 am |
|
|
