Hello, long time D3 G4 owner. Doesn’t do much now, only 600 miles last year (and 2 breakdowns). Everything runs fine and occasionally I get - engine system fault, limp mode and the code is U3F02. Which apparently doesn’t exist. Cycling the ignition makes the problem go away. I can clear the fault using OBD2 reader but then…. Randomly it reappears. Very frustrating. Any help gratefully received!!
Cheers
Dave
20th Mar 2022 6:11 pm
nigethecat
Member Since: 11 Sep 2016
Location: Marnoch
Posts: 4193
A quick Google on the web shows "U3F02" equals injector problems but that's on a Ford F350 could be something similar?I want to see the sweets before I get into your windowless van... I'm not stupid!
Corris Grey D4 Commercial SE 2016
Zermatt Sliver 2007 D3 SE manual (gone)
Indus Silver D4 HSE 2015 (gone)
Bonatti Grey D3 HSE 2006 (gone)
White D3 S (LHD) 2007 (gone)
Firenze Red D4 HSE 2014 (gone)
Black RRS 3.6TDV8 2008 (gone)
Rusty Green Defender 110 1997 (gone)
Black FL2 HSE 2013 (gone)
20th Mar 2022 6:20 pm
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 4907
I think that's an obscure Ford code, what diagnostics are you using?
Generic OBD scanners don't get to the heart of the matter with LR's and you are best served with dedicated LR diagnostics. (GAP et al)
As regards the fault and in the absence of diagnostic codes I can only suggest you check the wiring harness under the engine cover. ie Injectors and sensors for integrity. yµ (idµ - eAµ) ψ=mψ
Thanks! I’d found that on google but doesn’t make sense if the engine is PSA and engine/body ecu’s are land rover (although i think ford did own LR for a few minutes back then..). I’m using a very old BAS code reader. I think a more professional approach might be necessary !!
20th Mar 2022 8:03 pm
PROFSR G
Member Since: 06 Mar 2017
Location: Lost
Posts: 4907
Essentially its a Ford developed product with as you say joint PSA/Ford engine. The diagnostics (codes etc) are all Ford based which is why you are seeing an obscure Ford dtc!
Get a GAP diagnostics or similar tool on it and it should point the direction. yµ (idµ - eAµ) ψ=mψ
20th Mar 2022 8:49 pm
Globetrotter448
Member Since: 21 Mar 2017
Location: Londonderry NSW
Posts: 1798
"U" codes are basically information only and your fault of limp mode should give a more definitive code. As has been said, the codes need reading.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum