KING2
Member Since: 25 Feb 2022
Location: Moscow
Posts: 10
  
|
| FBH protocol by CAN network |
|
Hi!
I have D3 with Webasto and 1533 timer fitted (russian climate pack), so Webasto can be run from 1533 timer (now I have cheap chinese car alarm just emulating pressing timer button, to turn pre-heater on and off - just as temporary solution).
But if you have D3 woken up (multimedia screen is lighting) you cannot turn Webasto on - it tried to start and immediately goes off. This means if you start АИР to heat a car, you should wait until it will heated up, not opening the car (but maybe I want to place something into a car and I want Webasto to run until I will start the car, not just open it).
As I understand, car's CAN bus contains some messages that turns off everything commanded over W-Bus, so I decided to make some research, maybe it is possible to send commands to Webasto over CAN network instead of W-Bus?
Maybe somebody made something about this and can share something with me?
Message IDs, protocols, fields, or something, just not to start from empty place?
Thank you in advance!
|
 26th Feb 2022 1:56 pm |
|
|
