Member Since: 12 Aug 2020
Location: Henley-on-Thames
Posts: 111
BCM Errors - Key/coil/starting issues?
Hi All
I'm getting the below codes on my IID once I've started the D3, and wondering if anyone had any guidance on it? The car does take a few seconds to start, but I put that down to it just being a V8 in winter!
They come back every time I clear them and then start the vehicle, so trying to work out if I need to do something or just ignore them?
B1B02-28 (2F) Low frequency coil - General signal failure - signal bias level is out of range/zero adjustment failure
B1BA0-66 (2F) Excessive challenge requests or start attempt in storage mode - Algorithm based failure - signal has too many transitions/events
B1C57-14 (2F) Passive start ignition relay coil circuit - General electrical failure - circuit short to ground or open
13th Jan 2021 2:04 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10549
I expect they all do that sir.
Don’t worry about it.
14th Jan 2021 12:23 am
pagoda
Member Since: 13 Aug 2009
Location: Not London Anymore (or the US for that matter)
Posts: 1928
With the exception of being left in snow for 4 days at -20 in Canada, my V8 never had problems/was slow starting and never showed those codes (it actually did start - just, which quite amazed me).
Assume you've tried the usual suspects of cleaning the MAF, throttle body, checking the gaps on the plugs and replacing, etc, coils. Also worth chucking a can of BG44K in the tank if you haven't done that for a while.
Try that lot.PAGODA
14th Jan 2021 1:32 am
gstuart
Member Since: 21 Oct 2016
Location: kent
Posts: 13878
Pete K wrote:
I expect they all do that sir.
Don’t worry about it.
Hi mate
Funny enough When I first bought my D3 I had something similar to that , think it was relating to the light around the ign key
For me it cured the issue when I recharged the battery overnight , however ur know considerably more than myself as it may be a totally different error
Ps, hope ur good
14th Jan 2021 5:04 am
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10549
Low freq coil could be the key imboliser pickup I guess.
But if it starts. It works.
14th Jan 2021 7:39 am
gstuart
Member Since: 21 Oct 2016
Location: kent
Posts: 13878
Many thanks and Indeed very good point
Also as a side note replacing my Exide EA1000 to the yuasa has been a big improvement
Stay safe
14th Jan 2021 8:51 am
tgreer
Member Since: 12 Aug 2020
Location: Henley-on-Thames
Posts: 111
pagoda wrote:
With the exception of being left in snow for 4 days at -20 in Canada, my V8 never had problems/was slow starting and never showed those codes (it actually did start - just, which quite amazed me).
Assume you've tried the usual suspects of cleaning the MAF, throttle body, checking the gaps on the plugs and replacing, etc, coils. Also worth chucking a can of BG44K in the tank if you haven't done that for a while.
Try that lot.
Doing physical remidies next, just working through error codes and making sure it's not related to that before I take half my engine bay apart!
14th Jan 2021 2:23 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10549
Mine gives these straight after clearing
B1B02-28 (2F) Low frequency coil - General signal failure - signal bias level is out of range/zero adjustment failure
B1C57-14 (2F) Passive start ignition relay coil circuit - General electrical failure - circuit short to ground or open
16th Jan 2021 3:31 pm
eightfoot
Member Since: 12 Apr 2015
Location: sunny essex
Posts: 783
mine too,also get 3-4 others that have always come back straight after clearing them,never been a problem just ignore themplease excuse any grammer/punctuation mistakes,i'm thick,thankyou
current vehicles 2005 d3 2013 d4
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum