Member Since: 08 Sep 2020
Location: Buckley, North Wales
Posts: 1150
Cheers so it can only be done with a block underneath?
Engine on
extended mode
Block underneath
Brake down and hold up extension
Done?
Do I have to put a piece of wood under both sides to achieve it? Or is there a central area to put 1?
I just want to show off to my son so ideally don’t want to be going under
Tia
7th Jan 2021 5:46 pm
Yargo
Member Since: 25 Dec 2020
Location: Europe
Posts: 326
Put it in off road mode, put something under a car. Put it in access mode. Car will try to lower down, but won`t be able to, due to the blockage, then it will go into extended mode to avoid this obstacle. Just make sure doors are closed.
7th Jan 2021 5:51 pm
aja4x4
Member Since: 14 Apr 2019
Location: Westbury
Posts: 2462
You cannot put it into super extended mode only the car can do it if theres a obstruction under the car.
If you have gap lld you can raise it to whatever height you want
7th Jan 2021 6:41 pm
DG Site Moderator
Member Since: 12 Dec 2005
Location: The Gaff
Posts: 50971
The motor will go into extended mode when it grounds ..but super-extended does involve using the brake and sus lever as seen here with my first D3 on Chapel Gate lane back in 2006.
Member Since: 03 Jan 2006
Location: Romiley
Posts: 13710
Run it through a lake - when it starts to get deep and the vehicle starts to think about floating a bit, the wheels will reach down in the water looking for the bottom
Can only find the lake photo from 2006!
Steve N | 21MY Defender | 08MY Discovery 3 (history) | 06MY Discovery 3 (ancient history)
7th Jan 2021 11:44 pm
garrycol
Member Since: 06 Dec 2010
Location: Canberra
Posts: 1119
You can only access super extended mode when the car has gone into extended mode - you cannot select extended mode, to get into this the car has to be grounded or as advised - go into offroad height and put the jack or block of wood hard up under the chassis and then lower - the car will then go into extended mode and then using the instructions you have you can select Super Extended - OR you can do what I have, you can buy a LLAMs kit and select whatever height you want whenever you want.
Garry
8th Jan 2021 4:41 am
cmb2020
Member Since: 08 Sep 2020
Location: Buckley, North Wales
Posts: 1150
Hey what’s the bottom line cheapest way to get a control like the LLAMS kit please?
Apart from a wooden block lol
I’d absolutely love to cruise around at max height would be a proper head Turner in my Chelsea tractor looking d3 haha 😆
And thanks again all
Gonna try the wood block tomorrow
8th Jan 2021 8:21 pm
Yargo
Member Since: 25 Dec 2020
Location: Europe
Posts: 326
xxxxx
8th Jan 2021 9:03 pm
cmb2020
Member Since: 08 Sep 2020
Location: Buckley, North Wales
Posts: 1150
Just thinking, I’ve got an Autel ap200 diagnostic tool: it can calibrate the suspension by typing the heigh in mm of each wheel.. maybe I could say it’s lower than it is, so its tricked to extend higher!
Or would that do damage along the line of software / mechanical actions?
8th Jan 2021 11:34 pm
cmb2020
Member Since: 08 Sep 2020
Location: Buckley, North Wales
Posts: 1150
Does this look like the highest siuspension mode my fellow disco family?
9th Jan 2021 2:24 pm
DG Site Moderator
Member Since: 12 Dec 2005
Location: The Gaff
Posts: 50971
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum