Member Since: 13 Jun 2017
Location: Fylde Coast
Posts: 44
ARB Drop Link - Suspension Now Stuck in Extended mode
Had the dreaded MOT today - failed on one point which is good news. Offside rear anti roll bar drop link was missing - I think this may have been a victim of a recent pay and play day.
Had the drop link replaced and now the car is sat very high up on the suspension at the rear. Dropping it to access height makes it think there is an obstacle and the car jumps up to extended mode. The front is raising and lowering but not to the same level as the rear.
Got an intermittent suspension fault on the way home from the garage as well.
Is there anything I can do to fully reset the suspension height all around to normal? I dont have an IID tool or anything myself.
Image to show:
Any advice will be welcome as usual.2006 Discovery 3 - HSE Auto
9th Oct 2018 6:25 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20787
Check the height sensor link is still attached to the suspension arm My D3 Build Thread
Member Since: 13 Jun 2017
Location: Fylde Coast
Posts: 44
Nailed it Mikey.
I had checked all the height sensor rods themselves and they seemed fine. Gave it a little wiggle near the suspension arm and its just pulled away. Snapped right off near the arm itself.
Thanks
Now just to fix it...2006 Discovery 3 - HSE Auto
9th Oct 2018 6:58 pm
JJSA
Member Since: 12 Feb 2009
Location: Aberdeenshire
Posts: 6
Hi D3lta & Mikey
I really hope this is what's happened to mine. Had my Disco in for compressor replacement and dealer just phoned me, swearing that he's fed up trying to solve this problem, suspecting a broken wire. He described exact same symptoms: normal height front and stuck in extended height at the back.
How did you end up fixing it D3elta? Did you have to replace the sensor link?
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
