Advertise on DISCO3.CO.UK
Forum · Gallery · Wiki · Shop · Sponsors
DISCO3.CO.UK > Technical (D3)

Instrument Cluster Fixed
Post Reply  Down to end
Page 1 of 1
RichardK
 


Member Since: 18 Jan 2006
Location: Western Australia
Posts: 295

Australia 2009 Discovery 3 TDV6 S Auto Atacama SandDiscovery 3
Instrument Cluster Fixed

Well after many months and a lot of research I have finally got my IC fixed.

After the last thread I put on here I looked up the Russian (?) post on the resoldering of the two chips and decided it was worth following up, I translated the Russian post courtesy of Google and decided I didn't want to attempt to desolder and resolder the chips myself, I rang around locally and found a computer repair shop who said that would be no problem.

When I took it in he backed away at the chips because of the amount of resin coating on them saying the removal of that would be too risky but he did say that my resoldering of the connector pins wasn't as good as it should be so he would desolder them and resolder.

Picked it up yesterday, total cost AUD$40, installed it and since then have done over 150km and not a problem so I am very confident problem is now solved.

Cheers
RichardK
 2009 Discovery S 3, BAS tune, EGR Delete, ARB winch bar, Milemarker hyd winch, HF and UHF radios, Rear spare wheel carrier, Roof rack,
Touring: Australian Offroad Matrix IV Camper 
 
Post #214577613th May 2020 1:34 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO3.CO.UK is independent and not affiliated to Land Rover.
Switch to Mobile Site